A prototype for the instrumented decay tunnel of ENUBET was tested in 2018 at the CERN East Area facility with charged particles up to 5 GeV . This detector is a longitudinal sampling calorimeter with lateral scintillation light readout. The calorimeter was equipped by an additional “t0-layer” for timing and photon discrimination. The performance of this detector in terms of electron energy resolution, linearity, response to muons and hadron showers are presented in this paper and compared with simulation. Thet0-layer was studied both in standalone mode using pion charge exchange and in combined mode with the calorimeter to assess the light yield and the 1 mip/2 mip separation capability. We demonstrate that this system fulfills the requirements for neutrino physics applications and discuss performance and additional improvements.
Neutrino oscillation physics has entered a new precision era, which poses major challenges to the level of control and diagnostics of the neutrino beams. In this paper, we review the design of high-precision beams, their current limitations, and the latest techniques envisaged to overcome such limits. We put emphasis on “monitored neutrino beams” and advanced diagnostics to determine the flux and flavor of the neutrinos produced at the source at the per-cent level. We also discuss ab-initio measurements of the neutrino energy–i.e., measurements performed without relying on the event reconstruction at the detector–to remove any flux induced bias in the determination of the cross sections.
26 November 2018 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
We summarize in this paper the detector R&D performed in the framework of the ERC ENUBET Project. We discuss in particular the latest results on longitudinally segmented shashlik calorimeters and the first HEP application of polysiloxane-based scintillators.
Monitored neutrino beams are facilities where beam diagnostics enable the counting and identification of charged leptons in the decay tunnel of a narrow band beam. These facilities can monitor neutrino production at the single particle level (flux precision %) and provide information about the neutrino energy at the 10% level. The ENUBET Collaboration has demonstrated that lepton monitoring might be achieved not only by employing kaon decays but also by identifying muons from the decays and positrons from the decay-in-flight of muons before the hadron dump. As a consequence, beam monitoring can be performed using the ENUBET technique even when the kaon production yield is kinematically suppressed. This finding opens up a wealth of opportunities for measuring neutrino cross-sections below 1 GeV. In this paper, we investigate this opportunity at the European Spallation Source (ESS), which is an ideal facility to measure and cross-sections in the 0.2–1 GeV range. We also describe the planned activities for the design of this beam at the ESS within the framework of the ESSSB+ design study, which was approved by the EU in July 2022.
1 December 2020 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment