In recent years, the development of biodegradable materials from renewable sources based on polymeric biomaterials have grown rapidly due to increase environmental concerns and the shortage of petroleum sources. In this regard, naturally renewable polymers such as starch has shown great potential as environmental friendly materials. Besides, the unique properties of starch such as biodegradable and non-toxic, biocompatible and solubility make them useful for a various biomedical applications. Regardless of their unique properties, starch materials are known to have limitations in term of poor processability, low mechanical properties, poor long term stability and high water sensitivity. In order to overcome these limitations, the incorporation of nano size fillers into starch materials (nanocomposites) has been introduced. This review aims to give an overview about structure and characteristics of starch, modification of starch by nanocomposites and their potential for biomedical applications.
This study present the preparation of potato starch film with glycerol as a plasticizer through a solution casting technique. The effect of glycerol with varying concentrations (10%, 30%, 50% and 70%) on the tensile, microstructure and physical properties of potato starch film was investigated. Results shows that the increase of glycerol content caused the decrease in tensile strength, with the highest value of 13MPa was recorded for starch film containing 10% glycerol, whereas the elongation at break increased as the glycerol content increased from 10%-30%. Nevertheless, the elongation at break for plasticized films significantly decreased at a higher glycerol content due to anti-plasticization effect. Besides, the microstructure of the starch films showed gradual smoother surface, homogenous and good distribution, as the glycerol content increased. The thickness and moisture content of the films increased with increasing glycerol content due to the hygroscopic behavior of the plasticizer. Overall result shows that the addition of glycerol in potato starch film significantly influenced the properties of the films.
12 June 2018 in IOP Conference Series: Materials Science and Engineering
The semiconductor industry faces the dual challenge of risk assessment and process improvement. This paper introduces a framework that integrates Failure Mode and Effects Analysis (FMEA) and Plan-Do-Check-Act (PDCA) cycle to address these challenges effectively. FMEA serves as the initial step to identify potential risks within the system, followed by applying the PDCA cycle to systematically address and enhance the identified risks. The comparison between the initial Risk Priority Number (RPN) value, determined through FMEA, and the post-RPN in PDCA value gauges the success of the framework. Implementing the system in a semiconductor assembly line yielded a significant 51% improvement in RPN, with additional Lean tools incorporated into PDCA, such as SMART goals, 6M, and multi-voting. This integrated framework amplifies risk management, fosters continuous improvement, optimizes resource utilization, and empowers data-driven decisions, ultimately bolstering organizational growth. However, the study acknowledges limitations such as its single-case focus and potential RPN calculation subjectivity.