Forces induced by quantum fluctuations of the electromagnetic field control adhesion phenomena between rough solids when the bodies are separated by distances of approximately . However, this distance range remains largely unexplored experimentally in contrast with the shorter (van der Waals forces) or the longer (Casimir forces) separations. The reason for this is the pull-in instability of the systems with the elastic suspension that poses a formidable limitation. In this paper we propose a genuine experimental configuration that does not suffer from the short distance instability. The method is based on the adhered cantilever, whose shape is sensitive to the forces acting near the adhered end. The general principle of the method, its possible realization, and feasibility are extensively discussed. The dimensions of the cantilever are determined by the maximum sensitivity to the forces. If the adhesion is defined by strong capillary or chemical interactions, the method loses its sensitivity. Special discussion is presented for the determination of the minimum distance between the rough solids upon contact, and for the compensation of the residual electrostatic contribution. The proposed method can be applied to any kind of solids (metals, semiconductors, or dielectrics) and to any intervening medium (gas or liquid).
Water electrolysis performed in microsystems with a fast change of voltage polarity produces optically invisible nanobubbles containing H2 and O2 gases. In this form the gases are able to the reverse reaction of water formation. Here we report extreme phenomena observed in a millimeter-sized open system. Under a frequency of driving pulses above 100 kHz the process is accompanied by clicking sounds repeated every 50 ms or so. Fast video reveals that synchronously with the click a bubble is growing between the electrodes which reaches a size of 300 μm in 50 μs. Detailed dynamics of the system is monitored by means of a vibrometer by observing a piece of silicon floating above the electrodes. The energy of a single event is estimated as 0.3 μJ and a significant part of this energy is transformed into mechanical work moving the piece. The observations are explained by the combustion of hydrogen and oxygen mixture in the initial bubble with a diameter of about 40 μm. Unusual combustion mechanism supporting spontaneous ignition at room temperature is responsible for the process. The observed effect demonstrates a principal possibility to build a microscopic internal combustion engine.
Using different experimental techniques we visualize a cloud of gas in water that is produced electrochemically by the alternating polarity process. Liquid enriched with gas does not contain bubbles strongly scattering visible light but its refractive index changes significantly near the electrodes. The change of the refractive index is a collective effect of bulk nanobubbles with a diameter smaller than 200 nm. Any alternative explanation fails to explain the magnitude of the effect. Spatial structure of the cloud is investigated with the optical lever method. Its dynamics is visualised observing optical distortion of the electrode images or using differential interference contrast method. The cloud covers concentric electrodes, in a steady state it is roughly hemispherical with a size two times larger than the size of the electrode structure. When the electrical pulses are switched off the cloud disappears in less than one second. The total concentration of gases can reach very high value estimated as 3.5 × 1020 cm−3 that corresponds to an effective supersaturation of 500 and 150 for hydrogen and oxygen, respectively.