Vicarious calibration and validation techniques are important tools to ensure the long-term stability and inter-sensor consistency of satellite sensors making observations in the solar-reflective spectral domain. Automated test sites, which have continuous in situ monitoring of both ground reflectance and atmospheric conditions, can greatly increase the match-up possibilities for a wide range of space agency and commercial sensors. The Baotou calibration and validation test site in China provides operational high-accuracy and high-stability vicarious calibration and validation for high spatial resolution solar-reflective remote-sensing sensors. Two sites, given the abbreviations BTCN (an artificial site) and BSCN (a natural sandy site), have been selected as reference sites for the Committee on Earth Observation Satellites radiometric calibration network (RadCalNet). RadCalNet requires sites to provide data in a consistent format but does not specify the required operational conditions for a RadCalNet site. The two Baotou sites are the only sites to date that make spectral measurements for their continuous operation. One of the core principles of RadCalNet is that each site should have a metrologically rigorous uncertainty budget which also describes the site’s traceability to the international system of units, the SI. This paper shows a formalized metrological approach to determining and documenting the uncertainty budget and traceability of a RadCalNet site. This approach follows the Guide to the Expression of Uncertainty in Measurement. The paper describes the uncertainty analysis for bottom-of-atmosphere and top-of-atmosphere reflectance in the spectral region from 400 to 1000 nm for the Baotou sites and gives preliminary results for the uncertainty propagating this to top-of-atmosphere reflectance.

Unregulated livestock breeding and grazing can degrade grasslands and damage the ecological environment. The combination of remote sensing and artificial intelligence techniques is a more convenient and powerful means to acquire livestock information in a large area than traditional manual ground investigation. As a mainstream remote sensing platform, unmanned aerial vehicles (UAVs) can obtain high-resolution optical images to detect grazing livestock in grassland. However, grazing livestock objects in UAV images usually occupy very few pixels and tend to gather together, which makes them difficult to detect and count automatically. This paper proposes the GLDM (grazing livestock detection model), a lightweight and high-accuracy deep-learning model, for detecting grazing livestock in UAV images. The enhanced CSPDarknet (ECSP) and weighted aggregate feature re-extraction pyramid modules (WAFR) are constructed to improve the performance based on the YOLOX-nano network scheme. The dataset of different grazing livestock (12,901 instances) for deep learning was made from UAV images in the Hadatu Pasture of Hulunbuir, Inner Mongolia, China. The results show that the proposed method achieves a higher comprehensive detection precision than mainstream object detection models and has an advantage in model size. The $mAP$ of the proposed method is 86.47%, with the model parameter 5.7 M. The average recall and average precision can be above 85% at the same time. The counting accuracy of grazing livestock in the testing dataset, when converted to a unified sheep unit, reached 99%. The scale applicability of the model is also discussed, and the GLDM could perform well with the image resolution varying from 2.5 to 10 cm. The proposed method, the GLDM, was better for detecting grassland grazing livestock in UAV images, combining remote sensing, AI, and grassland ecological applications with broad application prospects.

The field of view (FOV) of pushbroom hyperspectral imager is limited by the compromise of the detector scale and requirements of spatial resolution. Combining imagers along the sampling direction effectively expands its FOV and improves the imaging efficiency. Due to the small overlapping area between the adjacent imagers, stitching the images using traditional methods need a large amount of ground control points (GCPs) or additional strips, which reduce the efficiency of both image acquisition and processing. This paper proposed a new method to precisely stitch images acquired from multiple pushbroom imagers. First, the relative orientation model was built based on the homonymy points to calculate the relative relationship between the adjacent imagers. Then rigorous geometric imaging model was adopted to generate a seamless stitching image. Simulation data was used to verify the accuracy of the method and to quantitatively analyze the effect of different error sources. Results show that the stitching accuracy is better than two pixels. Overall, this method provides a novel solution for stitching airborne multiple pushbroom images, to generate the seamless stitching image with wide FOV.

Comparing satellite retrieval with high-precision ground observations is an essential component for the validation of CO₂ satellite products. The initial stage of assessing the bias in retrieval products from satellite and ground sources involves establishing a geographical connection between observations that are temporally and spatially proximate. The primary aim of this paper is to evaluate the influence of variations in neighborhood definitions and colocation methods on the assessment of satellite products and provide quantitative references. To achieve this, a series of experiments were conducted involving the Global Total Column Carbon Observation Network (TCCON) and the OCO-2 satellite. Various spatial-temporal neighborhoods and colocation methods were considered in these experiments. The results indicate that spatial neighborhoods exert a more substantial influence on bias compared to temporal neighborhoods. In the mid-latitudes of the Northern Hemisphere, there is an observed linear increase trend between the difference of OCO-2 and TCCON observations and the spatial neighborhood, with an average increase of 0.32 ppm as the neighborhood size changes from 1$°$ to 10$°$. Regarding colocation methods, the simple spatiotemporal geographic constraints tend to overlook changes in the atmospheric state to a certain extent. The target geographic constraint method reduces the bias by 2% to 5% by increasing the proportion of OCO-2 observations targeting TCCON while the method of introducing T₇₀₀ potential temperature reduces by 2% to 13% by screening the gradient of CO₂ concentration change. Moreover, an evident correlation exists between the bias and their corresponding latitudes, with a 0.20 ppm increase in bias observed for every 10$°$ increment in latitudes in the Northern Hemisphere. The bias of TCCON and OCO-2 shows a pronounced seasonal regularity, with the highest in summer. The study also discusses the selection of spatiotemporal matching with low satellite coverage, the bias distribution, and the attribution of bias to the natural wind field.

Robust calibration and validation (Cal and Val) should guarantee the accuracy of the retrieved information, make the remote sensing data consistent and traceable, and maintain the sensor performance during the operational phase. The DRAGON program has set up many remote sensing research topics on various application domains. In order to promote the effectiveness of data modeling and interpretation, it is necessary to solve various challenges in Cal and Val for quantitative RS applications. This project in the DRAGON 4 program aims to promote the cooperation of the Cal and Val experts from European and Chinese institutes in Cal and Val activities, and several achievements have been obtained in the advanced on-orbit optical sensor calibration, as well as microwave remote sensor calibration and product generation. The outcomes of the project have benefited the related remote sensing modeling and product retrieval, and promoted the radiometric calibration network (RadCalNet) as an international operational network for calibration, intercalibration, and validation. Moreover, this project provided local governments with a more accurate OMI NO₂ data in China, which were used to study the air quality control during APEC period, Parade period and G20 period. This will be of ongoing be value for monitoring atmospheric environmental quality and formulating pollution control strategies.

Accurate quantification of methane (CH₄) emissions from individual point sources is essential for understanding localized greenhouse gas dynamics and supporting mitigation strategies. This study employs satellite-based point-source emission rate data from the Carbon Mapper initiative, combined with ERA5 meteorological reanalysis, to simulate near-surface CH₄ dispersion using a Gaussian plume model coupled with Monte Carlo simulations. This approach captures local dispersion characteristics around each emission source. Simulations driven by these emission inputs reveal a highly skewed, heavy-tailed concentration distribution (consistent with log-normal characteristics), where the 95th percentile (1292.1 ppm) significantly exceeds the mean (475.9 ppm), indicating the dominant influence of a small number of super-emitters. Sectoral analysis shows that coal mining contributes the most high-emission sites, while the solid waste and oil & gas sectors present higher per-source intensities, averaging 1931.1 ppm and 1647.6 ppm, respectively. Spatially, emissions are concentrated in North and Northwest China, particularly Shanxi Province, which hosts 62 high-emission sites with an average maximum of 1583.9 ppm. Sensitivity analysis reveals that emission rate perturbations produce nearly linear responses in concentration, whereas wind speed variations induce an inverse and asymmetric nonlinear response, with sensitivity amplified under low wind speed conditions (a ±30% change in wind speed results in more than ±25% variation in concentration). Under stable atmospheric conditions (Class E), concentrations are approximately 1.3 times higher than those under weakly unstable conditions (Class C). Monte Carlo simulations further indicate that output uncertainty peaks within 150–300 m downwind of emission sources. These results provide a quantitative basis for improving uncertainty characterization in satellite-based methane inversion and for prioritizing risk-based monitoring strategies.