Waheed M. Salem

Dr. Waheed M. Salem


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 February 2023 in Catalysts
Verified
Journal Article
Open access
PDF file
Ahmed EidAhmed Eid
Ahmed Eid
Amr FoudaAmr Fouda
Amr Fouda
SHSaad El-Din Hassan
Saad El-Din Hassan
Mohammed F. HamzaMohammed F. Hamza
Mohammed F. Hamza
NANada Alharbi
Nada Alharbi
WSWaheed M. Salem
Waheed M. Salem
Herein, the aqueous extract of Portulaca oleracea has been used as a safe, cheap, eco-friendly, and applicable scale-up method to bio-fabricate copper oxide nanoparticles (CuO-NPs). The character of CuO-NPs were determined using UV-vis spectroscopy, Fourier transform infrared (FT-IR), X-ray diffraction (XRD), Transmission electron microscopy (TEM), Energy dispersive X-ray(EDX), Dynamic light scattering (DLS), and zeta potential. Spherical and crystalline CuO-NPs with a size range of 5–30 nm at a maximum surface plasmon resonance of 275 nm were successfully fabricated. The main components of the green-synthesized particles were Cu and O with weight percentages of 49.92 and 28.45%, respectively. A Zeta-potential value of −24.6 mV was recorded for CuO-NPs, indicating their high stability. The plant-based CuO-NPs showed promising antimicrobial and catalytic activity in a dose-dependent manner. Results showed that the synthesized CuO-NPs had the efficacy to inhibit the growth of pathogens Staphylococcus aureus, Bacillus subtilis, Escherichia coli, Pseudomonas aeruginosa, and Candida albicans with low MIC values in the ranges of 6.25–25 µg/mL. The highest decolorization percentages of tanning wastewater were attained under sunlight irradiation conditions at a concentration of 2.0 mg/mL after 200 min with percentages of 88.6 ± 1.5% compared to those which were recorded under dark conditions (70.3 ± 1.2%). The physicochemical parameters of tanning wastewater including total suspended solids (TSS), total dissolved solids (TDS), chemical oxygen demand (COD), biological oxygen demand (BOD), and conductivity under optimum conditions were significantly decreased with percentages of 95.2, 86.7, 91.4, 87.2, and 97.2%, respectively. Interestingly, the heavy metals including cobalt (Co), lead (Pb), nickel (Ni), cadmium (Cd), and chromium (Cr (VI)) decreased with percentages of 73.2, 80.8, 72.4, 64.4, and 91.4%, respectively, after treatment of tanning wastewater with CuO-NPs under optimum conditions. Overall, the plant-synthesized CuO-NPs that have antimicrobial and catalytic activities are considered a promising nano-catalyst and environmentally beneficial to wastewater treatment.

24 April 2021 in Materials
Verified
Journal Article
Open access
PDF file
Mohammed F. HamzaMohammed F. Hamza
Mohammed F. Hamza
NHNora A. Hamad
Nora A. Hamad
DHDoaa M. Hamad
Doaa M. Hamad
MKMahmoud S. Khalafalla
Mahmoud S. Khalafalla
AAAdel A.-H. Abdel-Rahman
Adel A.-H. Abdel-Rahman
WSWaheed M. Salem
Waheed M. Salem
Efficient removal of Cd(II) and Pb(II) from contaminated water is considered a fundamental point of view. Synthetic hydrogel biopolymers based on chitosan and alginate (cost-effective and eco-friendly) were successfully designed and characterized by highly efficient removal contaminants. The sorbents are characterized by FTIR, SEM-EDX, TGA, XPS analyses and textural properties which are qualified by N2 adsorption. The sorption properties are firstly investigated by the effect of pH, sorption isotherms, uptake kinetics, and selectivity from multi-metal solution with equi-molar concentration. The sorbent with 1:3 ratios (of chitosan and alginate respectively) is the most effective for metal removal (i.e., 0.81 mmol Cd g−1 and 0.41 mmol Pb g−1). Langmuir and Sip’s models fitted better the adsorption isotherms compared to the Freundlich model. Uptake kinetics was well fitted by pseudo-first-order rate equation, while the saturation was achieved within 40 min. The sorbent shows good reproducibility through duplicate the experiments with negligible decreasing efficiency (>2.5%). The sorbent was applied for water treatment on samples collected from the industrial area (i.e., 653 and 203 times over the MCL for Cd(II) and Pb(II) respectively according to WHO). The concentration of Cd and Pb was drastically decreased in the effluents as pH increased with removal efficiency up to 99% for both elements at pH 5.8 and SD equivalent 1 g L−1 for 5 h.

11 February 2021 in Polymers
Verified
Journal Article
Open access
PDF file
Mohamed El-NewehyMohamed El-Newehy
Mohamed El-Newehy
HEHany El-Hamshary
Hany El-Hamshary
WSWaheed M. Salem
Waheed M. Salem
Cellulose has been one of the most widespread materials due to its renewability, excellent mechanical properties, biodegradability, high absorption ability, biocompatibility and cheapness. Novel, simple and green colorimetric fibrous film sensor was developed by immobilization of urease enzyme (U) and tricyanofuran hydrazone (TCFH) molecular probe onto cellulose nanofibers (CNF). Cellulose acetate nanofibers (CANF) were firstly prepared from cellulose acetate using the simple, green and low cost solution blowing spinning technology. The produced CANF was exposed to deacetylation to introduce CNF, which was then treated with a mixture of TCFH and urease enzyme to introduce CNF-TCFH-U nanofibrous biosensor. CNF were reinforced with tricyanofuran hyrazone molecular probe and urease enzyme was encapsulated into calcium alginate biopolymer to establish a biocomposite film. This CNF-TCFH-U naked-eye sensor can be applied as a disposable urea detector. CNF demonstrated a large surface area and was utilized as a carrier for TCFH, which is the spectroscopic probe and urease is a catalyst. The biochromic CNF-TCFH-U nanofibrous biosensor responds to an aqueous medium of urea via a visible color signal changing from off-white to dark pink. The morphology of the generated CNF and CNF-TCFH-U nanofibrous films were characterized by different analytical tools, including energy-dispersive X-ray patterns (EDX), polarizing optical microscope (POM), Fourier-transform infrared spectroscopy (FT-IR) and scanning electron microscope (SEM). SEM images of CNF-TCFH-U nanofibers demonstrated diameters between 800 nm and 2.5 μm forming a nonwoven fabric with a homogeneous distribution of TCFH/urease-containing calcium alginate nanoparticles on the surface of CNF. The morphology of the cross-linked calcium alginate nanoparticles was also explored using transmission electron microscopy (TEM) to indicate an average diameter of 56–66 nm. The photophysical performance of the prepared CNF-TCFH-U was also studied by CIE Lab coloration parameters. The nanofibrous film biosensor displayed a relatively rapid response time (5–10 min) and a limit of detection as low as 200 ppm and as high as 1400 ppm. Tricyanofuran hydrazone is a pH-responsive disperse dye comprising a hydrazone detection group. Determination of urea occurs through a proton transfer from the hydrazone group to the generated ammonia from the reaction of urea with urease.

25 September 2023 in Environmental Science and Pollution Research
Verified
Journal Article
Open access
PDF file
EMEmad A. Matter
Emad A. Matter
ADAbdel ghaffar Dehmees
Abdel ghaffar Dehmees
WSWaheed M. Salem
Waheed M. Salem
MEMahmoud Osman Abd El-Magied
Mahmoud Osman Abd El-Magied
GAGaber Hashem Gaber Ahmed
Gaber Hashem Gaber Ahmed
With the growing need for high-purity rare-earth elements (REEs), the separation of these REEs has received much attention recently. The objective of this research is to produce chitosan from shrimp waste, then modify it with different functionality, and investigate the adsorption properties of chitosan adsorbents towards La(III) ions. First, from shrimp waste, chitosan (ch) with a significant degree of deacetylation, purity, and solubility was produced. The purified chitosan was cross-linked with epichlorohydrin (ep), and then, it was modified with 3,6,9,12-tetraazatetradecane-1,14-diamine (HA) to produce polyaminated chitosan (HA@ep@Ch). The polycarboxylated/imine chitosan (CM@HA@ep@Ch) was obtained by treating polyaminated chitosan with chloroacetic acid in isopropyl alcohol. The chitosan adsorbents were characterized and applied for lanthanum recovery from synthetic and monazite leach liquor samples. The factors controlling the recovery process were studied and discussed. The performance of the adsorbents was achieved through equilibrium, dynamic, and isothermal studies. HA@ep@Ch and CM@HA@ep@Ch showed good performance for lanthanum recovery with a maximum capacity of 114.52 and 141.76 mg/g at 330 K, respectively. The isotherm parameters refer to the monolayer of lanthanum adsorbed into the adsorbents through chelation and ion exchange mechanisms. A 0.5-M HCl solution was found effective to elute 95.8% of the adsorbed lanthanum on HA@ep@Ch, and 93.4% of the adsorbed lanthanum on CM@HA@ep@Ch. The adsorbents showed greater selectivity in extracting La, Ce, Pr, Nd, and Sm (62–75%) from REE leach liquid compared to extracting other REEs (20–41%).

11 February 2023 in Gels
Verified
Journal Article
Open access
PDF file
Khalid A.M. SalihKhalid A.M. Salih
Khalid A.M. Salih
KZKanggen Zhou
Kanggen Zhou
Mohammed F. HamzaMohammed F. Hamza
Mohammed F. Hamza
HMHamed Mira
Hamed Mira
Yuezhou WeiYuezhou Wei
Yuezhou Wei
WSWaheed M. Salem
Waheed M. Salem
Although Cs(I) and Sr(II) are not strategic and hazardous metal ions, their recovery from aqueous solutions is of great concern for the nuclear industry. The objective of this work consists of designing a new sorbent for the simultaneous recovery of these metals with selectivity against other metals. The strategy is based on the functionalization of algal/polyethyleneimine hydrogel beads by phosphonation. The materials are characterized by textural, thermo-degradation, FTIR, elemental, titration, and SEM-EDX analyses to confirm the chemical modification. To evaluate the validity of this modification, the sorption of Cs(I) and Sr(II) is compared with pristine support under different operating conditions: the pH effect, kinetics, and isotherms are investigated in mono-component and binary solutions, before investigating the selectivity (against competitor metals) and the possibility to reuse the sorbent. The functionalized sorbent shows a preference for Sr(II), enhanced sorption capacities, a higher stability at recycling, and greater selectivity against alkali, alkaline-earth, and heavy metal ions. Finally, the sorption properties are compared for Cs(I) and Sr(II) removal in a complex solution (seawater sample). The combination of these results confirms the superiority of phosphonated sorbent over pristine support with promising performances to be further evaluated with effluents containing radionuclides.

21 June 2024 in Sustainability
Verified
Journal Article
Open access
PDF file
Mohammed F. HamzaMohammed F. Hamza
Mohammed F. Hamza
GEGehan El-Habibi
Gehan El-Habibi
AAAdel A.-H. Abdel-Rahman
Adel A.-H. Abdel-Rahman
MKMahmoud S. Khalafalla
Mahmoud S. Khalafalla
HAHamada H. Amer
Hamada H. Amer
SDSaly R. El Dakkony
Saly R. El Dakkony
A functionalized chitosan thiourea composite (CH-TU) was successfully synthesized using formaldehyde as a crosslinking agent for enhancing silver recovery from different aqueous solutions. Comparison sorption studies with a non-functionalized composite (CH-F) as a reference material were conducted. Grafting led to an improvement in the sorption performances, i.e., 0.763 mmol Ag g−1 for CH-F vs. 2.125 mmol Ag g−1 for CH-TU. The pseudo-first-order rate equation (PFORE) was fitted to the sorption kinetics at saturation times of 40 and 30 min for CH-F and CH-TU, respectively, while the sorption isotherms were fitted with Langmuir and Sips equations for both sorbents. Fourier transform infrared (FTIR), scanning electron microscopy (SEM), energy-dispersive X-ray analysis (EDX), nitrogen sorption–desorption isotherms (BET-surface area), elemental analysis, thermogravimetric analysis (TGA) and pH of the zero charge (pHpzc) were used to characterize and investigate the sorption mechanism. Sorption was performed three times to check the reproducibility, while the sorption performances were stable over 20 cycles, with a limited decrease in performance (5 and 3% for CH-F and CH-TU, respectively). Nitric acid solution (0.3 M) was efficient for desorbing the adsorbed metal ions. The grafted sorbent with thiourea is considered as a promising tool for recovering Ag(I) from acidic waste leachate derived from waste spent films.