We present a novel type of surface-enhanced Raman scattering (SERS) substrate constituted of a 3-dimensinal polymeric inverse opal (IO) photonic crystal frame with gold nanorods (Au-NRs) decorating on the top layer. This substrate employs resonant excitation as well as constructive backward scattering of Raman signals to produce large enhancement of SERS output. For the incoming excitation, Au-NRs with appropriate aspect ratio were adopted to align their longitudinal localized surface plasmon band with the excitation laser wavelength. For the outgoing SERS signal, the spectral position of the photonic band gap was tuned to reflect Raman-scattered light constructively. This SERS substrate produces not only strong but also uniform SERS output due to the well control of Au-NRs distribution by the periodic IO structure, readily suitable for sensing applications.
A novel hybrid surface-enhanced Raman scattering (SERS) substrate based on Au nanoparticles decorated inverse opal (IO) photonic crystal (PhC) is presented. In addition to the enhancement contributed from Au nanoparticles, a desired Raman signal can be selectively further enhanced by appropriately overlapping the center of photonic bandgap of the IO PhC with the wavelength of the Raman signal. Furthermore, the lattice structure of the IO PhC provides excellent control of the distribution of Au nanoparticles to produce SERS spectra with high uniformity. The new design of SERS substrate provides extra maneuverability for ultra-high sensitivity sensor applications.
26 September 2011 in Journal of Experimental Nanoscience
High-quality photonic crystals of SiO2 spheres and air spheres are fabricated using self-assembling processes and infiltration method with thermal-assistant cell method. Their photonic band structures are characterised by reflectivity spectra measurements. It shows that the tunable optical stop bands are determined by refractive index contrast, diameter of spheres and angle of light illumination. The experimental results of reflectivity spectra agree very well with the results obtained by theoretical Bragg diffraction and photonic band calculations.
Lanthanide (Ln3+)–doped upconversion nanoparticles (UCNPs) offer an ennormous future for a broad range of biological applications over the conventional downconversion fluorescent probes such as organic dyes or quantum dots. Unfortunately, the efficiency of the anti−Stokes upconversion luminescence (UCL) process is typically much weaker than that of the Stokes downconversion emission. Albeit recent development in the synthesis of UCNPs, it is still a major challenge to produce a high−efficiency UCL, meeting the urgent need for practical applications of enhanced markers in biology. The poor quantum yield efficiency of UCL of UCNPs is mainly due to the fol-lowing reasons: (i) the low absorption coefficient of Ln3+ dopants, the specific Ln3+ used here being ytterbium (Yb3+), (ii) UCL quenching by high−energy oscillators due to surface defects, impurities, ligands, and solvent molecules, and (iii) the insufficient local excitation intensity in broad-field il-lumination to generate a highly efficient UCL. In order to tackle the problem of low absorption cross-section of Ln3+ ions, we first incorporate a new type of neodymium (Nd3+) sensitizer into UCNPs to promote their absorption cross-section at 793 nm. To minimize the UCL quenching induced by surface defects and surface ligands, the Nd3+-sensitized UCNPs are then coated with an inactive shell of NaYF4. Finally, the excitation light intensity in the vicinity of UCNPs can be greatly enhanced using a waveguide grating structure thanks to the guided mode resonance. Through the synergy of these three approaches, we show that the UCL intensity of UCNPs can be boosted by a million−fold compared with conventional Yb3+–doped UCNPs.