In this study, a new reciprocating magnetorheological polishing (RMRP) method for a flat workpiece was proposed. Based on the RMRP principle and Preston equation, the material removal rate (MRR) model of the RMRP as well as its normal polishing pressure model was established. On this basis, the effects of different technological parameters including workpiece rotation speed, eccentric wheel rotation speed and eccentricity on the MRR of the workpiece were investigated. The K9 optical flat glass was polished with the RMRP setup to verify the MRR model. The experimental results showed that the effect of workpiece rotation speed on the MRR was much greater than that of eccentric wheel rotation speed and eccentricity, and the MRR increased from 0.0115 ± 0.0012 to 0.0443 ± 0.0015 μm/min as workpiece rotation speed rose. The optimum surface roughness reduced to Ra 50.8 ± 1.2 from initial Ra 330.3 ± 1.6 nm when the technical parameters of the workpiece rotation speed of 300 rpm, the eccentric wheel rotation speed of 20 rpm and the eccentricity of 0.02 m were applied. The average relative errors between the theoretical and experimental values were 16.77%, 10.59% and 7.38%, respectively, according to the effects of workpiece rotation speed, eccentric wheel rotation speed and eccentricity on MRR.
28 March 2020 in The International Journal of Advanced Manufacturing Technology
The dynamic recrystallization behavior of 42CrMo steel during the pre-stress hardening grinding (PSHG) process was investigated at temperatures ranging from 850–1150 °C and pre-stress from 0 MPa to 167 MPa. A coupled grain size model considering different grinding conditions was constructed to research the grinding process. Microstructure analyses showed that the hardening layer exhibits the typical features of dynamic recrystallization (DRX), and the evolution process of microstructure and grain size can be predicted properly by the model. The volume fraction of DRX grains increases with increasing pre-stress and grinding temperature. The critical condition for DRX grains occurring is that with a grinding depth of 150 µm, pre-stress is larger than 67 MPa, while most of the DRX grains occurred when pre-stress is larger than 100 MPa. Furthermore, the relationship between pre-stress and flow stress has been derived. The result shows that flow stress shows a linearly increasing trend, with the increase of pre-stress at the stage of lower strain.
High volume concentrated magneto-rheological (MR) fluids ( ) is applied in many industrial fields. In the presented paper, a distance weighted chain-based model for predicting field-induced rheological behavior of high volume concentrated MR fluids is proposed. Simulated by Monte Carlo program, two important parameters: distance coefficient and adjustment coefficient β are introduced to quantify the contribution of micro structure in MR suspension, which considered as the most significant difference between new model and the alternative: standard isolated chain model. For testifying the validity of distance weighted model, four sets of, including three synthetic hydrocarbon oil-based ( ) and a water-based self-prepared ( ) samples’ rheological experimental and reported shear stress data are employed or prepared. The comparison of experimental data and theoretical values calculated by two models shows that in general, gain insight of neighboring chain interaction in model of rheological behavior seems indispensable. Implication of this model include that coefficient and β are the potential option for obtaining correct estimation of in highly volume concentrated magnetorheological fluids.
6 January 2022 in The International Journal of Advanced Manufacturing Technology