A methodology is proposed to study the interplay between tooth wear and contact fatigue under elastohydrodynamic lubrication condition. The modeling methodology includes the influence of contact fatigue on wear and the influence of wear on contact fatigue. First, the changes in film pressure and film thickness of oil at each meshing point caused by contact fatigue are introduced according to the surface wear model, and the change of wear model is analyzed to study the effect of contact fatigue on wear. Then, according to the elastohydrodynamic lubrication theory, the change in film pressure affected by tooth surface wear is analyzed to study the effect of wear on contact fatigue. Finally, the influence of lubrication conditions on the interplay between tooth surface wear and contact fatigue is analyzed. In addition, an experimental fatigue study is performed and introduced into the model predictions to improve the accuracy of the proposed methodology.
25 March 2017 in The International Journal of Advanced Manufacturing Technology
The dynamic recrystallization behavior of 42CrMo steel during the pre-stress hardening grinding (PSHG) process was investigated at temperatures ranging from 850–1150 °C and pre-stress from 0 MPa to 167 MPa. A coupled grain size model considering different grinding conditions was constructed to research the grinding process. Microstructure analyses showed that the hardening layer exhibits the typical features of dynamic recrystallization (DRX), and the evolution process of microstructure and grain size can be predicted properly by the model. The volume fraction of DRX grains increases with increasing pre-stress and grinding temperature. The critical condition for DRX grains occurring is that with a grinding depth of 150 µm, pre-stress is larger than 67 MPa, while most of the DRX grains occurred when pre-stress is larger than 100 MPa. Furthermore, the relationship between pre-stress and flow stress has been derived. The result shows that flow stress shows a linearly increasing trend, with the increase of pre-stress at the stage of lower strain.
1 February 2013 in Bulletin of Earthquake Engineering
Laser-directed energy deposition (L-DED) technology is increasingly used in the manufacturing industry, in which the powder convergence of the feeding nozzle affects the accuracy and quality of additive manufacturing parts. However, there is nothing in the literature that gives a comprehensive optimization scheme for the powder feeding structure of the ring nozzle. In order to investigate the effect of the internal structure for the annular nozzle on powder convergence, in this paper, finite element analysis models for the annular nozzle are established, and the Lagrangian–Eulerian method is used to analyze the influence of different outlet shapes, powder feeding inclination angles, outlet gaps, and inlet shapes of annular nozzles on the powder convergence. The results indicate that the parallel outlet shape is more suitable for the annular nozzle, and the waist diameter of the powder stream decreases gradually with the decrease in the power feeding inclination angle and the outlet gap. The inlet shape of the powder storage chamber plays a guiding role in the moving direction of the powder particles; when the powder feeding inclination angle is 17° and the outlet gap is 0.5 mm, the waist diameter of the powder stream is reduced by 49%. In addition, the effects of particle size, carrier gas rate, and laser shielding gas on the powder convergence are also studied, and the results indicate that, with the reduction of particle size and carrier gas rate, the powder convergence can be effectively improved, and the waist diameter of powder stream becomes 1.42 mm. With the increase in the laser shielding gas rate, the powder convergence position moves down. The research results provide a basis for the structural optimization to design a high-convergence annular nozzle for the laser additive manufacturing process.