In the eye lens cell membrane, the lipid composition changes during the aging process: the proportion of sphingomyelins (SM) increases, that of phosphatidylcholines decreases. To investigate the protective role of the SMs in the lens cell membrane against oxidative damage, analytical techniques such as electrochemistry, high-resolution mass spectrometry (HR-MS), and atomic force microscopy (AFM) were applied. Supported lipid bilayers (SLB) were prepared to mimic the lens cell membrane with different fractions of PLPC/SM (PLPC: 1-palmitoyl-2-linoleoyl-sn-glycero-3-phosphocholine). The SLBs were treated with cold physical plasma. A protective effect of 30% and 44% in the presence of 25%, and 75% SM in the bilayer was observed, respectively. PLPC and SM oxidation products were determined via HR-MS for SLBs after plasma treatment. The yield of fragments gradually decreased as the SM ratio increased. Topographic images obtained by AFM of PLPC-bilayers showed SLB degradation and pore formation after plasma treatment, no degradation was observed in PLPC/SM bilayers. The results of all techniques confirm the protective role of SM in the membrane against oxidative damage and support the idea that the SM content in lens cell membrane is increased during aging in the absence of effective antioxidant systems to protect the eye from oxidative damage and to prolong lens transparency.

In this study, thin films of CuFeO2 were prepared using radio frequency reactive sputtering (RF) and reactive high-power impulse magnetron sputtering combined with electron cyclotron wave resonance plasma (HiPIMS-ECWR). The plasma was characterized using an RF ion probe. Plasma density, tail electron energy, and electron temperature were extracted from the measured data. The films were deposited on fluorine-doped tin oxide-coated glass and quartz glass, with the substrates being heated during the deposition process. The final delafossite CuFeO2 structure was formed after annealing in an argon gas flow at 550–600 °C. The ideal deposition conditions were found to be with a stoichiometric ratio of Cu:Fe = 1:1, which was the optimal condition for creating the delafossite CuFeO2 structure. The measured optical bandgap of CuFeO2 was 1.4 eV. The deposited CuFeO2 films were subjected to photoelectrochemical measurements in the cathodic region to investigate their potential application in solar photocatalytic water splitting. The films showed photocatalytic activity, with a photocurrent density of around 70 μA/cm2 (under an incident light irradiation of 62 mW/cm2, AM 1.5 G). The electrochemical properties of the layers were studied using open circuit potential, linear voltammetry, and chronoamperometry. The surface morphology and chemical composition of the layers were analyzed by atomic force microscopy and energy-dispersive x-ray spectroscopy, respectively. The crystalline structure was determined using XRD and Raman spectroscopy. The results of these methods are presented and discussed in this article.