This research aimed to determine riveted carbon/epoxy composites’ mechanical performance when fabricated by resin transfer molding (RTM). As this manufacturing process is gaining importance in the aeronautics and automotive industries, assembly methods and their reliability must be studied in terms of their airworthiness and transportation implementation. The study case resumes the determination of the bearing strength of RTM-woven carbon composites for different rivet joint diameters (1/8, 5/32 and 3/16 in). The joint shear strength was obtained following the ASTM D5961 instructions, and post-failure analysis was carried out by a computerized tomography scan. A residual strength curve is provided with the results to infer the bearing strength for the riveted composites as a function of the rivet width-to-diameter ratio. A discussion of the fracture mechanism and tensile strength is carried out to assess the understanding of the riveted woven composites.
1 October 2020 in International Journal of Smart and Nano Materials
For more than 7 years, our research work is focussed upon the electrical behavior of carbon fiber reinforced composites. Effectively carbon/polymeric matrix laminates can be considered as an electrically conductive network (i.e. carbon fibers) embedded in an insulating medium (i.e. the polymeric matrix). Consequently, from an electrical point of view laminated composites have been modelled owing to combinations of electrical resistances (i.e. fibers themselves and the contact points between the fibers) and capacitances (i.e. polymeric matrix). During their manufacturing, composite material such as thermoset matrix composites for instance, undergo various changes in their physical (including electrical and mechanical) properties and in their geometrical characteristics. In fact, in the case of manufacturing processes such as oven curing (vacuum bag), autoclave curing or heating plate press, beside the chemo-rheological changes, the laminated parts are the place of a compaction phenomenon inducing changes in fiber volume fraction and thicknesses. The idea developed in this paper is that since the carbon/polymeric matrix laminate can be considered as an electrical network, it can then be view and used as a sensor for following the material state during the manufacturing process enabling thus defects to be detected and this without any additional sensing material or device.
4 March 2010 in International Journal of Material Forming