Phuc Le

Mr. Phuc Le

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 November 2022 in Journal of Mining Institute
Verified
Journal Article
Open access
PDF file
VZVladimir P. Zubov
Vladimir P. Zubov
PLPhuc Le
Phuc Le
DOI: 10.31897/PMI.2022.72 It is shown that the creation of the variants of resource-saving systems for the development of long-column mining is one of the main directions for improving the technological schemes for mining operations in the mines of the Kuang Nin coal basin. They provide a reduction in coal losses in the inter-column pillars and the cost of maintaining...

18 June 2020 in E3S Web of Conferences
Verified
Conference Paper
Open access
PDF file
PLPhuc Le
Phuc Le
VZVladimir Zubov
Vladimir Zubov
TDThang Pham Duc
Thang Pham Duc
Problems in surrounding rock displacement, roadway deformation and complex support are the hallmarks of the long wall mining system. Such problems seriously affect the safety and efficient production of coal mines. To control the deformation of the rocks around the roadway next to the goaf, to reduce the support pressure, in Vietnamese underground mines often leave supporting coal pillars. Identification of a reasonable design for roadway supporting pillars by a numerical simulation study was conducted under the geological and technical foundation of I-10- 2 working faces at the Khe Cham coal mine, Vietnam . The characteristics of stress and pressure distribution of roof layers on coal pillars are modeled under different pillar widths. The results show a great linear increase of the vertical stress on the narrow coal pillar and as the width of the coal pillar increases, the area of the elastic core area also increases and the level of stress increase tends to be stable without any apparent uptrend. Coal pillar deformation decreases with increasing coal pillar width, but it leads to large coal loss and waste of resources. Therefore, with the current supporting solutions to increase the stability of the coal pillar, the size range of a coal pillar is determined to be 6-8 m through numerical simulation. The conclusions obtained may provide a certain reference number to choose the logical location of the furnace lines under similar geological conditions.

30 December 2025 in Mining of Mineral Deposits
Verified
Journal Article
Closed access
PLPhuc Le
Phuc Le
TVTien Trung Vũ
Tien Trung Vũ
Purpose. The stability of the lower coal seam roadway under the condition of close coal seams is a key issue in underground mining, mainly when the roadway is located under the coal pillar of the upper seam. This paper analyzes the stress distribution rule under the coal pillar to determine the reasonable location of the roadway in the lower seam at Thong Nhat Coal Mine, Vietnam. Methods. Numerical simulation model using FLAC3D software was conducted to investigate the distribution and redistribution of stress under the coal pillar and the goaf area, considering vertical-horizontal stress, physical parameters of rock and actual boundary conditions. Findings. Four different roadway layout locations were assumed for comparison: Under the center of the pillar (A), under the edge of the pillar (B, C) and in the floor area under the goaf (D). The results showed that the highest stress concentration was at location A, with a concentration coefficient of 2.4-2.7 times the initial stress, creating a high risk of instability. Locations B and C had lower stresses but were still strongly affected by the pillar load. In contrast, location D showed a significantly lower and uniform stress distribution, and a small plastic zone development range, which was favorable for maintaining roadway stability. Originality. The choice of roadway location is decisive for the safety and longevity of the project. In the geological conditions at Thong Nhat Coal Mine, arranging the roadway in the floor area under the goaf outside the coal pillar with a horizontal distance of 5m (location D) is the most reasonable and safest. At the same time, it is necessary to avoid arranging the roadway directly under the coal pillar. Practical implications. The research results provide a scientific and practical basis for design work, improving stability, reducing maintenance costs and ensuring safety in underground mines with close coal seams.

1 January 2022 in Mining informational and analytical bulletin
Verified
Journal Article
Closed access
PLPhuc Le
Phuc Le
PDP. N. Dmitriev
P. N. Dmitriev
VTVan Duy Than
Van Duy Than
YLYunpeng Li
Yunpeng Li
Распределение опорного давления в краевой части угольного пласта играет решающую роль в нестабильности вмещающих пород, формируя потенциальную опасность горных ударов на шахтах. С помощью физической модели в лаборатории и теоретического анализа напряженного состояния исследованы характеристики распределения зоны опорного давления. Определены область воздействия опорного давления в краевой части угольного пласта, положение пика напряжения, с четким разделением на стадии до и после обрушения основной кровли. Перед обрушением основной кровли пик напряжения располагается вблизи границы выработанного пространства с его максимальным значением. Под нагрузкой слоев кровли консоль основной кровли опускается, поворачивается и ломается на расстоянии примерно в 1-1,5 мощности пласта (по данным лабораторного моделирования). При этом пик напряжений перемещается внутрь массива угля сразу после обрушения основной кровли, в краевой части угольного пласта образуется зона пониженного напряжения. Результаты этого исследования могут быть очень полезны для объяснения причин некоторых динамических проявлений опорного давления основной кровли и для принятия необходимых решений для управления горным давлением на...

17 December 2025 in Геология и геофизика Юга России
Verified
Journal Article
Closed access
PLPhuc Le
Phuc Le
LKLinh Nguyen Khac
Linh Nguyen Khac
Никита БабырьНикита Бабырь
Никита Бабырь
TVThang Nguyen Van
Thang Nguyen Van
Underground coal mining is characterized by confined working conditions and significant occupational safety hazards. Specifically, development headings driven along the coal seam ahead of the longwall face present a high risk of roof falls and challenging roof control conditions. The aim of this study is to analyse the stress distribution and the development of plastic failure zones in the surrounding rock mass, based on the mining conditions of Seam No. 10 at the Ha Lam coal mine. The relevance of the work is driven by the critical need to ensure the stability of development headings under the abutment pressure influence of the advancing longwall face, in order to enhance both safety and extraction efficiency. The main method employed involves numerical modelling of the rock mass stress-strain state, validated with in-situ monitoring data. As a result, it was established that the roadway ahead of the longwall face is consistently subjected to an asymmetric stress regime, with the horizontal-to-vertical stress ratio exceeding 2.5. The plastic zone in the surrounding rock develops asymmetrically between the two ribs of the roadway, leading to an unbalanced load. The magnitude of the stress and the extent of the plastic deformation zone around the ventilation roadway are significantly greater than those around the haulage roadway. Consequently, a supplemental support strategy is required to enhance roadway stability as it approaches the longwall face during mining operations. This paper provides a reliable foundation for the Ha Lam mine and other underground coal mines in Vietnam in developing plans to ensure roadway stability, improve production efficiency, and enhance occupational safety Подземная добыча угля связана с ограниченными условиями работы и значительными рисками безопасности труда. В частности, горные выработки, проводимые по угольному пласту впереди очистного забоя, представляют собой зону повышенного риска обрушения кровли и сложностей с управлением кровлей. Целью данного исследования является анализ распределения напряжений и развития зон пластической деформации во вмещающих породах на основе условий отработки пласта № 10 шахты «Ха Лам». Актуальность работы обусловлена необходимостью обеспечения устойчивости подготовительных выработок в зоне опережающего влияния очистных работ для повышения безопасности и эффективности добычи. В качестве основного метода использовано компьютерное моделирование напряженно-деформированного состояния породного массива, верифицированное данными натурных наблюдений. В результате установлено, что выработка, расположенная впереди очистного забоя, постоянно находится в условиях асимметричного напряженного состояния, при этом коэффициент соотношения горизонтального и вертикального напряжения достигает значений свыше 2,5. Зона пластических деформаций развивается асимметрично между двумя боками выработки, что приводит к неравномерной нагрузке. Величина напряжений и степень распространения зоны пластической деформации вокруг вентиляционной выработки значительно больше, чем у транспортной выработки. Следовательно, необходим план дополнительного крепления для повышения устойчивости выработки по мере ее приближения к очистному забою. Данная статья служит надежной основой для шахты «Ха Лам» и других подземных угольных шахт Вьетнама при разработке планов по обеспечению устойчивости горных выработок, повышению эффективности добычи и безопасности труда