Two-dimensional metal oxide pseudocapacitors are promising candidates for size-sensitive applications. However, they exhibit limited energy densities and inferior power densities. Here, we present an electrodeposition technique by which ultrathin CeO2−x films with controllable volumetric oxygen vacancy concentrations can be produced. This technique offers a layer-by-layer fabrication route for ultrathin CeO2−x films that render Ce3+ concentrations as high as ~60 at% and a volumetric capacitance of 1873 F cm−3, which is among the highest reported to the best of our knowledge. This exceptional behaviour originates from both volumetric oxygen vacancies, which enhance electron conduction, and intercrystallite water, which promotes proton conduction. Consequently, simultaneous charging on the surface and in the bulk occur, leading to the observation of redox pseudocapacitive behaviour in CeO2−x. Thermodynamic investigations reveal that the energy required for oxygen vacancy formation can be reduced significantly by proton-assisted reactions. This cyclic deposition technique represents an efficient method to fabricate metal oxides of precisely controlled defect concentrations and thicknesses.
16 May 2023 in Applied Catalysis B: Environment and Energy
High boron steel is prone to brittle failure due to the boride distributed in it with net-like or fishbone morphology, which limit its applications. The Quenching and Partitioning (Q&P) heat treatment is a promising process to produce martensitic steel with excellent mechanical properties, especially high toughness by increasing the volume fraction of retained austensite (RA) in the martensitic matrix. In this work, the Q&P heat treatment is used to improve the inherent defect of insufficient toughness of high boron steel, and the effect mechanism of this process on microstructure transformation and the change of mechanical properties of the steel has also been investigated. The high boron steel as-casted is composed of martensite, retained austensite (RA) and eutectic borides. A proper quenching and partitioning heat treatment leads to a significant change of the microstructure and mechanical properties of the steel. The net-like and fishbone-like boride is partially broken and spheroidized. The volume fraction of RA increases from 10% in the as-cast condition to 19%, and its morphology also changes from blocky to film-like. Although the macro-hardness has slightly reduced, the toughness is significantly increased up to 7.5 J·cm−2, and the wear resistance is also improved.
Electrocaloric effect (ECE) offers an efficient and environmentally friendly route for solid-state cooling. Either positive or negative ECE could exhibit a large adiabatic temperature change (ΔT). Compared to the positive electrocaloric response, the investigation of negative ECE is lagging behind, largely due to the fact that its origin is still elusive. In this work, the negative ECE behavior of conventional ferroelectric thin films, namely 0.94(Bi0.5Na0.5)TiO3-0.06BaTiO3 (BNBT), was studied. A remarkable ΔT of −26.1 K was acquired near 160 °C under a moderate electric field of 875 kV/cm, attributing to the ferroelectric phase transition in the polar nanoregions from rhombohedral (R3c) to tetragonal (P4bm), as confirmed by temperature-dependent dielectric permittivity, Raman spectra, and x-ray reciprocal space mapping. The BNBT thin film presents a high electrocaloric coefficient (ΔT/ΔE) of 0.0298 K cm kV−1, transcending that of the most reported negative electrocaloric response of thin films.