The aim of this work was to develop processing methods that safeguard the quality and antimicrobial properties of H. illucens and B. mori oils. We adopted a vegetable diet for both insects: leftover vegetables and fruit for H. illucens and mulberry leaves for B. mori. First, alternative techniques to obtain a good oil extraction yield from the dried biomass of H. illucens larvae were tested. Traditional pressing resulted to be the best system to maximize the oil yield and it was successfully applied to B. mori pupae. Oil quality resulted comparable to that obtained with other extraction methods described in the literature. In the case of B. mori pupae, different treatments and preservation periods were investigated to evaluate their influence on the oil composition and quality. Interestingly, agar diffusion assays demonstrated the sensitivity of Gram-positive Bacillus subtilis and Staphylococcus aureus to H. illucens and B. mori derived oils, whereas the growth of Gram-negative Pseudomonas aeruginosa and Escherichia coli was not affected. This study confirms that fat and other active compounds of the oil extracted by hot pressing could represent effective antimicrobials against bacteria, a relevant result if we consider that they are by-products of the protein extraction process in the feed industry.

In this paper, the main chemical properties of Perilla seed oil (PO) obtained by mechanical pressing of Perilla seeds are reported. The analysis of fatty acid composition has highlighted a very high amount of (n-3) α-linolenic acid (ALA), more than 60%, higher than other ALA rich oils such as linseed and sacha inchi oils and similar to chia oil. PO has an important sterol (higher than 3000 mg/kg) and vitamin E (approx. 870 mg/kg) content, while biophenols are in quite low concentration. The analyzed sample showed a very low acid and peroxide value and this is the demonstration that, following the proper technological procedures, it is possible to obtain high quality oils even in presence of high α-linolenic acid concentrations.

The synthetic procedure as well as the main properties of obtained products of a group of complex esters are reported here. Complex esters were prepared using low molecular weight saturated fatty acids, trimethylolpropane and a dicarboxylic acid as a feedstock. By means of this procedure it is possible to obtain products having high viscosity and very good lubricating, thermal and cold properties. Thanks to the absence of unsaturations into the ester also the oxidation property is good, opening several application perspective for these products which are partly prepared from renewable source

Safflower (Carthamus tinctorius L.) is an underestimated and multipurpose crop resistant to environmental stresses. Its oil presents useful chemical–physical properties, potentially exploitable for industrial purposes as a bio-based lubricant. In this work safflower oil was applied as a less toxic alternative to mineral-based hydraulic fluids. The extracted oil was partially refined and the antioxidant tert-buthylhydroquinone (THBQ) was added at two concentrations (0.25 and 3.00 mg kg⁻¹). Efficiency tests of the obtained oil were carried out using an experimental test rig capable of simulating a real hydraulic system and performing severe short-duration work cycles with the aim of strongly accelerating the ageing of the tested oil. Oil performance was verified by monitoring hydraulic and chemical–physical parameters, which were correlated to the main lubricant properties through sensor detection and laboratory analysis in parallel. The results indicated that the safflower oil behaved well at both THBQ concentrations and showed good technical performance (operating pressure and temperature; flowrate and transmitted hydraulic power), though a higher THBQ concentration was necessary to protect the oil’s chemical–physical properties from worsening. In fact, the higher THBQ concentration allowed the test to be extended to 270 h, an improvement compared to the 150 h that was achieved with the lower THBQ concentration. Finally, the use of safflower oil for industrial and agricultural purposes seems feasible and would contribute toward the sustainability of the whole crop rotation in a prospective valuable circular economy.