Seed quality is an important issue in forestry as it is an essential parameter in the production of high quality planting material. Many factors may hinder the harvesting of high quality seeds, including an insufficient number of sunny days, external conditions in temperate climate zones, and fungal pathogens affecting development of seedlings. We undertook to develop a procedure maximizing seed protection and promoting the optimum physiological development of seedlings by examination of the impact of seed pelleting (a general seed protection method) on germination rates and seedling development of Scots pine (Pinus sylvestris L.). Germination of pelleted seeds was examined in relation to substrate (water vs. soil) and LED light spectrum (white vs. red-blue). Several dormancy breaking treatments were applied: stratification/scarification, and growth regulator treatments including gibberellic acid (GA₃), indole-3-acetic acid (IAA) and 1-naphthaleneacetic acid (NAA), to stimulate seed germination. Experiments included independent tests for each treatment (stratification/scarification and plant growth regulators), and combinations of both stratification/scarification and phytohormone treatments. The impacts of these treatments and various controlled germination conditions on the fluorescence of chlorophyll were analyzed using the maximum efficiency of photosystem II photochemistry parameter (Fv/Fm). In addition, chlorophyll a and b content in Scots pine seedlings germinated from pelleted seeds, were quantified using high-performance liquid chromatography (HPLC). The combined stratification/scarification and growth regulator treatment was the most effective germination promoting method for pelleted Scots pine seeds. Scots pine seeds are highly likely to be photoblastic. The best germination rate, while maintaining optimal physiological parameters, was achieved in acidic soil (pH 5.0) with white LED light.

There is an urgent need to develop new compensatory and human-safe methods for controlling invasive Heracleum species. This research aimed to determine the effectiveness of H. sosnowskyi control under microwave radiation and biochemical changes in tissues and sap after irradiation. In field experiments in southern Poland, the plants were cut and irradiated with a device generating electromagnetic waves (2.45 GHz, 32.8 kW/m²). The control efficacy of plants in the rosette phase irradiated for 5, 10, or 15 min was 20%, 100%, and 100%, respectively. The control efficacy of plants in the flowering phase irradiated for 7.5 or 15 min was 66% and 100%. The metabolomic analysis of tissues and sap of irradiated H. sosnowskyi showed significant changes, mainly in the content and composition of proteins and sugars. In tissues, the treatments resulted in protein denaturation and significant changes in the metabolism of amino acids and the glyoxylate and galactose pathways. The sap was rich in sugars, glutamic acid, glutamine, homoserine, serine, and methionine. More changes in metabolite levels were observed in the tissues irradiated for 7.5 min. In conclusion, microwave radiation of H. sosnowskyi for longer times, e.g., 10 and 15 min, efficiently controls it.

The paper presents the results of experiments involving the exposure of Scots pine (Pinus sylvestris L.) cones to microwave radiation. The pine cones were obtained from the Maskulińskie and Brzesko Forest Districts (both in Poland). Pine cone length, thickness, and weight were determined and found to be significantly different between the two locations. Pine cones were exposed to 2.45-GHz microwaves emitted by a horn antenna, which was either fixed or moving at a speed of 0.002 m s⁻¹ over the cones. Total microwave emission time ranged from 30 to 441 s, depending on the test variant. The measured parameters included changes in pine cone moisture content as well as the germination capacity and viability class of the extracted seeds. It was found that pine cone moisture content decreased on average by 0.3 to 6 %, depending on the amount of microwave radiation applied. It was found that pine cone size, the amount of microwave radiation, and the distance between the cones and the horn antenna affected seed germination and viability class. In most experimental variants, the seeds were damaged by microwaves. Viable seeds (classes I and II) were obtained after 30 s of exposure to microwave radiation from a fixed horn antenna positioned at a distance of 0.04 m over the cones. The application of a moving antenna positioned 0.14 m over the cones resulted in seeds of viability classes II and III following a single microwave sweep over the seeds.

Sosnowski hogweed is an invasive weed in eastern-middle Europe that is dangerous to human health and the environment. The efficacy of its control using chemical and mechanical methods is limited. Electromagnetic radiation (microwaves) could be an environmentally friendly alternative for controlling this species. This study aims to: (1) Determine the effect of varying microwave treatment (MWT) durations on the control of S. hogweed using a device emitting microwaves at 2.45 GHz, 32.8 kW/m²; (2) Evaluate the impact of MWT on soil by an ecotoxicological bioassays; (3) Analyze biochemical changes occurring in the roots during the process. A field study was performed to assess the efficacy of S. hogweed control using MWT in times from 2.5 to 15 min. The MWT-treated soil was collected immediately after treatment (AT) and tested using bioassays (Phytotoxkit, Ostracodtoxkit, and Microtox). Fourteen days AT, the MWT hogweed roots were dug out, air-dried, and analyzed for the content and composition of essential oil, sugars, and fatty acids. According to the ecotoxicological biotests, the MWT soils were classified as non-toxic or low-toxic. The regeneration of hogweed was observed only in non-treated plants (control). Hogweed MWT for 2.5–15 min did not regenerate up to 14 days AT. The average weight of roots in hogweed MWT for 15.0 min was ca. two times smaller than the control plants. Those roots contained significantly higher amounts of sugars and saturated fatty acids than the control. We did not find a correlation between S. hogweed root essential oil content and composition and MWT time. The main compounds of essential oil were p‑cymene and myristicin. No highly photosensitizing compounds were identified in the tested root oil. We conclude that MWT of S. hogweed could be an environmentally safe and prospective control method, but more studies are needed.

Invasive Japanese knotweed is one of Poland’s most aggressive and difficult-to-control species. New methods of control are of utmost importance. This study aimed to analyze young knotweed offshoots’ regeneration and physiological condition after treatment of their rhizomes with microwaves of high frequency. The fresh rhizomes were microwaved in the laboratory once for different times (from 5 to 60 s, interval 5 s). Next, in the greenhouse, the growth of offshoots and their biochemical state (spectrophotometry of leaves) were recorded in three measurement series. It was shown that the microwave treatment for 35 s directly destroys knotweed rhizomes of a diameter of 1–3 cm, so it does not produce new offsprings. The treatment times from 5–25 s delay offspring regeneration and growth and development of leaves. The leaves initiate the mechanisms of protection against microwave stress in offshoots grown from the rhizomes exposed to microwaves for 10 s (increase in the anthocyanin index) and the 5 or 20 s treatments (higher values of the photochemical reflectance index). Based on the effective dose (ED50) analysis, the threshold of harmful effects of microwaves on the growth and development of Reynoutria japonica rhizomes was assumed to be 17–19 s.

Wildfires are becoming more frequent in Central Europe, raising questions about the mechanical and chemical integrity of fire-affected conifer wood. Because commercial species such as silver fir (Abies alba), Norway spruce (Picea abies), and Scots pine (Pinus sylvestris) are not evolutionarily adapted to fire, their thermo-mechanical response remains poorly quantified. This study investigates oven-dry density, static bending strength, compressive strength parallel to the grain, Brinell hardness, chemical composition, elemental composition, and heat of combustion of wood collected from a recent post-fire stand in Poland. Fire exposure resulted in a slight reduction in oven-dry density, while compressive and bending strengths increased relative to reported reference values, likely due to moisture depletion and partial thermal modification of cell-wall polymers. Chemical analyses showed moderate thermally induced shifts, including higher lignin and carbon content with depth, consistent with progressive carbonization of the affected tissues. Although surface-affected wood retained measurable mechanical capacity and energy value, its structural applicability remains constrained by potential brittleness and the limited sampling depth. These findings provide essential baseline data for evaluating post-fire conifer wood and its potential use in low-grade material and bioenergy applications.