Nurulhuda Bashirom

Dr. Nurulhuda Bashirom

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 July 2018 in Nanotechnology
Verified
Journal Article
Closed access
PDF file
NBNurulhuda Bashirom
Nurulhuda Bashirom
WTWai Kian Tan
Wai Kian Tan
GKGo Kawamura
Go Kawamura
MAMATSUDA Atsunori
MATSUDA Atsunori
KRKhairunisak Abdul Razak
Khairunisak Abdul Razak
ZLZAINOVIA LOCKMAN
ZAINOVIA LOCKMAN
Visible-light-active freestanding zirconia (ZrO 2 ) nanotube (FSZNT) arrays were fabricated by a facile electrochemical anodization method in fluoride containing ethylene glycol electrolyte added to it was 1 vol% of potassium carbonate (K 2 CO 3 ) at 60 V for 1 h. Poor adhesion at the metal∣oxide interface was induced by K 2 CO 3 leading to the formation of FSZNT flakes. The effect of the crystal structures of the FSZNTs e.g., amorphous, amorphous/tetragonal, and tetragonal/monoclinic was investigated towards the photocatalytic reduction of 10 ppm hexavalent chromium, Cr(VI) at pH 2 under sunlight. The results demonstrate the amorphous FSZNTs exhibited the highest Cr(VI) removal efficiency than the crystalline FSZNTs (95% versus 33% after 5 h). The high photocatalytic activity of the amorphous FSZNTs can be attributed to enhanced Cr(VI) adsorption, high visible light absorption, and better charge carrier separation. The low photocatalytic activity of the crystalline FSZNTs annealed at 500 °C was mainly attributed to poor Cr(VI) adsorption, low visible light absorption, and less photoactive monoclinic-ZrO 2 .

13 March 2021 in Catalysts
Verified
Journal Article
Open access
PDF file
SRSiti Azlina Rosli
Siti Azlina Rosli
NANurhaswani Alias
Nurhaswani Alias
NBNurulhuda Bashirom
Nurulhuda Bashirom
SIsyahriza ismail
syahriza ismail
WTWai Kian Tan
Wai Kian Tan
ZLZAINOVIA LOCKMAN
ZAINOVIA LOCKMAN
In this paper, titanium–dioxide (TiO2) nanotubes (TNTs) are formed by anodic oxidation with a fluorinated glycerol–water (85% and 15%, respectively) electrolyte to examine the effect of fluoride ion concentration, time, and applied voltage on TNT morphologies and dimensions. For fluoride ion concentration, the surface etching increases when the amount of ammonium fluoride added to the electrolyte solution increases, forming nanotube arrays with a clear pore structure. At a constant voltage of 20 V, TNTs with an average length of ~2 µm are obtained after anodization for 180 min. A prolonged anodization time only results in a marginal length increment. The TNT diameter is voltage dependent and increases from approximately 30 nm at 10 V to 310 nm at 60 V. At 80 V, the structure is destroyed. TNTs formed at 20 V for 180 min are annealed to induce the TiO2 anatase phase in either air or nitrogen. When ethylenediaminetetraacetic acid is added as a hole scavenger, 100% hexavalent chromium removal is obtained after 120 min of sunlight exposure for nitrogen-annealed TNTs.

1 May 2020 in Materials Research Express
Verified
Journal Article
Open access
PDF file
NBNurulhuda Bashirom
Nurulhuda Bashirom
WTWai Kian Tan
Wai Kian Tan
GKGo Kawamura
Go Kawamura
AMAtsunori Matsuda
Atsunori Matsuda
ZLZAINOVIA LOCKMAN
ZAINOVIA LOCKMAN
This paper presents the fabrication of self-organized ZrO2, TiO2, and α-Fe2O3 nanotube arrays by anodization of Zr, Ti, and Fe foils, respectively in fluoride-containing EG electrolyte at 40 V for 20 min. The as-anodized nanotubes were annealed in a tube furnace at 400 °C for 3 h to induce the crystallization of the oxide film. Morphology, crystal structure, surface properties, and optical properties of the anodic ZrO2 nanotubes (ZNTs), TiO2 nanotubes (TNTs), and α-Fe2O3 nanotubes (FNTs) were characterized by Field-Emission Scanning Electron Microscopy (FESEM), Transmission Electron Microscopy (TEM), x-ray Diffraction (XRD), Fourier-Transform Infrared (FTIR) spectroscopy, Photoluminescence (PL) spectroscopy, and UV–visible Near-Infrared Diffuse Reflectance Spectra (UV–vis NIR DRS) spectroscopy, respectively. Based on the FESEM and TEM micrographs, ZNTs possessed the longest nanotubes (i.e. 9.6 μm) compared with TNTs and FNTs under the same anodization condition. The aspect ratio of the nanotubes can be arranged in the order of ZNTs > FNTs > TNTs. The surface of the annealed ZNTs, FNTs, and TNTs was enriched with –OH groups to facilitate the Cr(VI) adsorption. According to the UV–vis NIR DRS spectra, strong visible light absorption was observed on the FNTs due to their low band gap. Whereas, the TNTs predominantly absorbs the UV light at λ max = 360 nm. Rapid Cr(VI) removal was observed on FNTs, i.e. 100% after 2 h activated by sunlight with negligible Cr(VI) removal for ZNTs and TNTs. When exposed to UVC (λ = 254 nm), only 39% versus 37% Cr(VI) removal efficiencies were obtained on TNTs and ZNTs after 3 h suggesting sluggish electron transfer due to rapid charge carriers recombination as evident in the PL spectra.

16 June 2022 in Journal of Materials Research and Technology
Verified
Journal Article
Open access
NBNurulhuda Bashirom
Nurulhuda Bashirom
WTWai Kian Tan
Wai Kian Tan
GKGo Kawamura
Go Kawamura
AMAtsunori Matsuda
Atsunori Matsuda
ZLZainovia Lockman
Zainovia Lockman

1 January 2018 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
PDF file
NBNurulhuda Bashirom
Nurulhuda Bashirom
MZMuhammad Afiq Zulkifli
Muhammad Afiq Zulkifli
SSSubagja Subagja
Subagja Subagja
WTWai Kian Tan
Wai Kian Tan
MAMATSUDA Atsunori
MATSUDA Atsunori
ZLZAINOVIA LOCKMAN
ZAINOVIA LOCKMAN
Self-organized TiO2 nanotube (TNT) arrays were fabricated by anodic oxidation of titanium foil in three different fluoride electrolytes: ethylene glycol (EG), glycerol, and sodium sulfate (Na2SO4) at different voltage and anodization time. In these electrolytes, the TNTs were produced in ∼ 2 µm long, but at the different diameter. The size of inner diameter can be arranged from the largest to the smallest value in the order of glycerol > EG > Na2SO4. Crystallization of the TNTs by annealing was led to the formation of anatase-TiO2. The sample can be activated under natural sunlight for reduction of hexavalent chromium, Cr(VI) into trivalent chromium, Cr(III). The reduction was thought to occur via synergistic reactions between adsorption and photoreduction. The result demonstrates 100 % of Cr(VI) removal efficiency over the TNTs grown in EG after 120 min. Whereas, only 48 % and 45 % of Cr(VI) can be removed over the TNTs fabricated in glycerol and Na2SO4, respectively. High photocatalytic activity of the TNTs-EG can be attributed to high crystallinity of anatase phase, enhanced Cr(VI) adsorption, and less electron-hole recombination due to smoother tube walls.

6 December 2023 in Materials Today: Proceedings
Verified
Journal Article
Closed access
FJFarah Juliana Jelaini
Farah Juliana Jelaini
NBNurulhuda Bashirom
Nurulhuda Bashirom
NFNur Hanis Nadirah Che Fauzi
Nur Hanis Nadirah Che Fauzi
NINorain Isa
Norain Isa