An electrochemical aptasensor is a compact analytical device where the bioreceptor (aptamer) is coupled to a transducer surface to convert a biological interaction into a measurable signal (current) that can be easily processed, recorded and displayed. Since the discovery of the Systematic Evolution of Ligands by Enrichment (SELEX) methodology, the selection of aptamers and their application as bioreceptors has become a promising tool in the design of electrochemical aptasensors. Aptamers present several advantages that highlight their usefulness as bioreceptors such as chemical stability, cost effectiveness and ease of modification towards detection and immobilization at different transducer surfaces. In this review, a special emphasis is given to the potential use of electrochemical aptasensors for the detection of protein disease biomarkers using voltammetry techniques. Methods for the immobilization of aptamers onto electrode surfaces are discussed, as well as different electrochemical strategies that can be used for the design of aptasensors.
Replacing synthetic surfactants by natural alternatives when formulating nanoemulsions has gained attention as a sustainable approach. In this context, nanoemulsions based on sweet almond oil and stabilized by saponin from Quillaja bark with glycerol as cosurfactant were prepared by the high-pressure homogenization method. The effects of oil/water (O/W) ratio, total surfactant amount, and saponin/glycerol ratio on their stability were analyzed. The formation and stabilization of the oil-in-water nanoemulsions were analyzed through the evaluation of stability over time, pH, zeta potential, and particle size distribution analysis. Moreover, a design of experiments was performed to assess the most suitable composition based on particle size and stability parameters. The prepared nanoemulsions are, in general, highly stable over time, showing zeta potential values lower than −40 mV, a slight acid behavior due to the character of the components, and particle size (in volume) in the range of 1.1 to 4.3 µm. Response surface methodology revealed that formulations using an O/W ratio of 10/90 and 1.5 wt% surfactant resulted in lower particle sizes and zeta potential, presenting higher stability. The use of glycerol did not positively affect the formulations, which reinforces the suitability of preparing highly stable nanoemulsions based on natural surfactants such as saponins.