Qi Jing

Dr. Qi Jing

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2021 in Adsorption Science & Technology
Verified
Journal Article
Open access
PDF file
QJQi Jing
Qi Jing
SQShuo Qiao
Shuo Qiao
WXWenyu Xiao
Wenyu Xiao
LTLe Tong
Le Tong
ZRZhongyu Ren
Zhongyu Ren
In this study, nano zero-valent iron-reduced graphene oxide (NZVI-rGO) composites were synthesized to remove 2,4-dichlorophenol (2,4-DCP) as an efficient adsorbent. Scanning electron microscopy (SEM) and X-ray diffraction (XRD) indicated that NZVI particles were successfully loaded and dispersed uniformly on rGO nanosheets. Fourier transform infrared spectroscopy (FTIR) analysis showed that the interaction between NZVI-rGO and 2,4-DCP promoted the adsorption process. A three-level, four-factor Box-Behnken design (BBD) of the response surface methodology (RSM) was used to optimize the influencing factors including NZVI-rGO dosage, 2,4-DCP initial concentration, reaction time and initial pH. A statistically significant, well-fitting quadratic regression model was successfully constructed to predict 2,4-DCP removal rate. The high value (15.95), very low value (<0.0001), nonsignificant lack of fit, and appropriate coefficient of determination ( ) demonstrate a good correlation between the experimental and predicted values of the proposed model. The analyses of variance reveal that NZVI-rGO dosage and reaction time have a positive effect on 2,4-DCP removal, whereas the increase of contaminant concentration and initial pH inhibit the removal, whereas the effect of contaminant concentration and initial pH is in reverse, where the change of NZVI-rGO dosage has the greatest effect. The optimum condition is1.215 g/L of NZVI-rGO dosage, 20.856 mg/L of 2,4-DCP concentration, 4.115 of pH, and 8.157 min of reaction time. It is verified by parallel experiments under the optimum condition, achieving the removal efficiency of100%.

HDHuang dan
Huang dan
ZRZhongyu Ren
Zhongyu Ren
XLXiaoyu Li
Xiaoyu Li
QJQi Jing
Qi Jing
Chitosan-stabilized nano zero-valent iron (CTS-nZVI) prepared by the liquid-phase reduction method has been shown to achieve a good dispersion effect. However, there has been little analysis on the mechanism affecting its stability and transport in saturated porous media. In this paper, settling experiments were conducted to study the stabilization of CTS-nZVI. The transport of CTS-nZVI in saturated porous media at different influencing factors was studied by sand column experiments. The stability mechanism of CTS-nZVI was analyzed from the point of view of colloidal stability by settling experiments and a zeta potential test. The theoretical model of colloidal filtration was applied for the calculation of transport coefficients on the basis of the column experiments data. Considering attachment–detachment effects, a particle transport model was built using HYDRUS-1D software to analyze the transport and spatial distribution of CTS-nZVI in a sand column.

15 July 2019 in Water Science & Technology
Verified
Journal Article
Closed access
YZYongxiang Zhang
Yongxiang Zhang
ZTZhenjun Tian
Zhenjun Tian
QJQi Jing
Qi Jing
YCYuanyuan Chen
Yuanyuan Chen
XHXuezheng Huang
Xuezheng Huang
In this study, a novel composite of modified diatomite supported nanoscale zero-valent iron (mD-NZVI) was synthesized and characterized. The effects of four factors (mD-NZVI dose, temperature, contact time and initial pH) on the removal of Cr(VI) by mD-NZVI were studied by experimental work and analyzed by response surface methodology (RSM). A second-order polynomial equation fitted by Box-Behnken design was used as a statistical model and proved to be precise in describing the significance of four factors. The analysis results show that the effects of four factors on the removal efficiency of Cr(VI) were significant (F value is 19.83), initial pH was found to be the key factor. In addition, the effect of initial pH was further studied and the maximum removal efficiency of 89.34% was obtained at pH of 3, the decrease in removal efficiency with the increase in pH is a synergistic effect of Cr(VI) species, surface charge of mD-NZVI and OH− amount at different pH.

8 April 2020 in Catalysts
Verified
Journal Article
Open access
PDF file
YLyajun Li
yajun Li
YZYongXiang Zhang
YongXiang Zhang
QJQi Jing
Qi Jing
YLYuhui Lin
Yuhui Lin
Nano zero-valent iron (NZVI) is widely used for reducing chlorinated organic pollutants in water. However, the stability of the particles will affect the removal rate of the contaminant. In order to enhance the stability of nano zero-valent iron (NZVI), the particles were modified with F-127 as an environmentally friendly organic stabilizer. The study investigated the effect of the F-127 mass ratio on the colloidal stability of NZVI. Results show that the sedimentation behavior of F-NZVI varied at different mass ratios. A biphasic model was used to describe the two time-dependent settling processes (rapid sedimentation followed by slower settling), and the settling rates were calculated. The surface morphology of the synthesized F-NZVI was observed with a scanning electron microscope (SEM), and the functional groups of the samples were analyzed with Fourier Transform Infrared Spectroscopy (FTIR). Results show that the F-127 was successfully coated on the surface of the NZVI, and that significantly improved the stability of NZVI. Finally, in order to optimize the removal rate of 2,4-dichlorophenol (2,4-DCP) by F-NZVI, three variables were tested: the initial concentration 2,4-DCP, the pH, and the F-NZVI dosage. These were evaluated with a Box-Behnken Design (BBD) of response surface methodology (RSM). The experiments were designed by Design Expert software, and the regression model of fitting quadratic model was established. The following optimum removal conditions were determined: pH = 5, 3.5 g·L−1 F-NZVI for 22.5 mg·L−1 of 2,4-DCP.

14 September 2023 in Polymers
Verified
Journal Article
Open access
PDF file
QJQi Jing
Qi Jing
YMYuheng Ma
Yuheng Ma
静何静雯 何
静雯 何
ZRZhongyu Ren
Zhongyu Ren
Nanoscale zero-valent iron (NZVI) is a material that is extensively applied for water pollution treatment, but its poor dispersibility, easy oxidation, and inconvenient collection limit its application. To overcome these drawbacks and limit secondary contamination of nanomaterials, we confine NZVI supported by reduced graphene oxide (rGO) in the scaffold of sodium alginate (SA) gel beads (SA/NZVI-rGO). Scanning electron microscopy showed that the NZVI was uniformly dispersed in the gel beads. Fourier transform infrared spectroscopy demonstrated that the hydrogen bonding and conjugation between SA and rGO allowed the NZVI-rGO to be successfully embedded in SA. Furthermore, the mechanical strength, swelling resistance, and Cr(VI) removal capacity of SA/NZVI-rGO were enhanced by optimizing the ratio of NZVI and rGO. Interestingly, cation exchange may drive Cr(VI) removal above 82% over a wide pH range. In the complex environment of actual Cr(VI) wastewater, Cr(VI) removal efficiency still reached 70.25%. Pseudo-first-order kinetics and Langmuir adsorption isotherm are preferred to explain the removal process. The mechanism of Cr(VI) removal by SA/NZVI-rGO is dominated by reduction and adsorption. The sustainable removal of Cr(VI) by packed columns could be well fitted by the Thomas, Adams–Bohart, and Yoon–Nelson models, and importantly, the gel beads maintained integrity during the prolonged removal. These results will contribute significant insights into the practical application of SA/NZVI-rGO beads for the Cr(VI) removal in aqueous environments.

28 October 2025 in Journal of Environmental Chemical Engineering
Verified
Journal Article
Closed access
SZShuyang Zhou
Shuyang Zhou
ZRZhongyu Ren
Zhongyu Ren
LYLin Yang
Lin Yang
CZChenglin Zhu
Chenglin Zhu
WXWenxiu Xie
Wenxiu Xie
QJQi Jing
Qi Jing