The unsteady laminar heat transfer and fluid flow phenomena inside a water storage tank during its static mode of operation and submitted to heat losses to the environment has been investigated by means of CFD and heat transfer numerical simulations. A parametric study has been carried out considering several situations and varying the aspect ratio, insulation thickness, initial temperature, and tank volume. In order to characterize the cooling process, a nondimensional analysis has been performed. From the analysis of the results of several detailed numerical simulations, correlations for the Nusselt number at the lateral, top, and bottom walls have been obtained. The verification of the mathematical model assumed, together with the verification and validation of the results, have also been pointed out.
Buildings exhibit a high energy consumption compared with other economic sectors. While percentages vary from country to country, buildings are responsible for approximately 40% of the global energy demand. Most of this is consumed for achieving human thermal comfort. In Colombia, the government promotes policies for the adoption of efficient energy strategies in this sector. The earth to air heat exchanger (EAHE) can be used to reduce the cooling load of a building. Therefore, this study aims to evaluate the energy savings that can be obtained by installing an EAHE in a tropical climate in Colombia. To do so, a mathematical model is implemented in TRNSYS (Transient System Simulation Tool) to predict the thermal performance and the cooling capacity of the EAHE. The system is modeled as a function of pipe length, diameter, material, thickness and air mass flow. Moreover, soil, local atmospheric conditions and building features are taken into account. It is found that the air leaves the EAHE at temperatures between 20.9 °C and 24.1 °C, which are approximately 3 °C below ambient temperature. Furthermore, the economic feasibility of the project is verified. Thereby, it is demonstrated that the EAHE can be a competitive alternative to current HVAC systems.
Combustion is the main method of converting biomass to energy, either by direct heating systems or by boilers. By means of CFD models, it is possible to optimize the behavior of those systems and improve significantly its performance, without incurring the economic and environmental cost of experimental studies. However, modelling of biomass combustion is a complex process that requires a large number of sub-models and computational resources for a detailed description, therefore, different approaches have been developed which depend on the system and simulation objective. In this work, a review of the state of art of modelling of solid biomass combustion in the last years is presented, including classification, description and analysis of several of the main models about the subject.
Governments have established regulations to reduce energy consumption and polluting gas emissions from buildings. In Colombia, the government issued Resolution 0549 in 2015, a regulation that imposed savings percentages on different types of buildings. Builders have had to improve their designs to meet this standard. However, this task requires a detailed understanding of the energy behaviour of buildings. In the absence of follow-up data, this study performed energy characterisations of a group of 20 residential and office buildings located in a tropical climate using DesignBuilder software. The simulations show a notable influence of plug-in loads on energy consumption as well as favourable thermal comfort conditions for all categories except for the low-income category. Solar radiation through windows is the largest source of heat in buildings. Additionally, the study shows the impact of a set of energy-saving measures on energy consumption. The results of this study can help designers reduce the energy consumption of tropical buildings and/or meet energy performance standards.
1 July 2015 in Revista Fuentes El Reventón Energético