This paper deals with both size and shape of plastic zone in the vicinity of the crack edges. Determination of plastic zone is proposed using the three-dimensional finite element analysis. Both, linear elastic and elastic-plastic material models are considered in this paper. Subsequently, results of these approaches are compared and their applicability is evaluated. Geometry considered is a beam with L-shaped cross section containing a crack, as it is described below. Mentioned beam is subjected to mixed mode loading condition, that is represented by variable forces in the direction of global coordinate system. Evolution of plastic zones is observed and evaluated around the crack edges of the profile.
An experimental optical method has been developed for the measurement of opening and sliding notch face movements. The light passing through a thin slit is monitored by a photodiode detector. Two parts of the slit are fixed independently on the notch faces of the simulated crack. Dynamic variations of the notch face movements are recorded as an electric signal by an oscilloscope. The sensitivity of such displacement measurement is comparable with the wavelength of light. Dynamic mixed-mode stress intensity factors under shock loading were evaluated from the data obtained and subsequently compared with a numerical simulation by ANSYS software. As it was approved, the technique has shown sufficient sensitivity, good linearity, and measurement reliability. Due to its non-destructive nature and overall robustness, the arrangement is applicable even for structural component condition determination taking into consideration potentially unknown boundary conditions and the non-linear character of mechanical parameters.
The aim of this contribution is a theoretical study for the estimation of the dynamic stress intensity factor (DSIF) using results from an experimental measurement. Using optical methods, it is possible to determine individual displacements of crack surfaces in multiple distances from the crack tip. Based on the theoretical distribution of displacements in the crack front, the DSIF can be estimated using the displacement extrapolation method at each time step. The main motivation for this methodology is the difficulty of estimation DSIF in real structures. The described approach is consequently compared with conventional numerical methods and the applicability is evaluated.