The relation between rotation speed, air pressure and the velocity of air-rotary drilling using the down the hole method is determined in an empirical manner. For the study, velocity measurements are obtained for combinations of the aforementioned parameters during fieldwork for the installation of borehole heat exchangers near Lublin, Poland. The tests consider three drill bit diameters—110, 127 and 140 mm; three rotational speeds—20, 40 and 60 1/min; and three air pressures—16, 20 and 24 bar. The borehole heat exchangers need 100 m deep wells. The lithology consists mainly of loess and clays to 24 m, sand and carbonate rocks to 36 m, and marls and limestone to 100 m. It is found that the highest drilling velocity is achieved when the greatest pressure is applied, while the lowest drilling velocity is connected to the lowest pressure. However, the relation between rotation speed and drilling velocity is more complex, as drilling velocity seems to be more affected by depth. Therefore, lithology can be a major factor. The results may find direct use in drilling, and provide a basis for further studies on the optimization of drilling technology.

The rotary-percussion drilling method is a prospective way to decrease drilling costs. It is obvious, based on literature analyses and finished geothermal drilling, that the Lublin Basin can be perceived as the one where rotary-percussion drilling can be used to drill an overburden of shale rocks. The paper explained the geology of the Lublin Basin, its’ geological structures, and the possibility of the use of drilling with a down-the-hole hammer, which could significantly decrease the cost of the whole shale gas drilling investment. Data collected from the wells drilled in the Lublin Basin were compared and analyzed to determine the viability of rotary-percussion drilling. Provided analyses showed that using the rotary-percussion drilling method in the Lublin Basin had a greater possibility of application than in other Polish shale basins (Baltic and Podlasie).