We synthesized lead-free piezoelectric (Bi0.5Na0.5-xKx)TiO3 (BNKT) ceramics using a conventional solid-state reaction method. We have investigated the structural and electrical properties of the materials with x = 0.05 to 0.40. The X-ray diffraction (XRD) analysis suggests that the BNKT ceramics show the transition from rhombohedral to tetragonal structure. The ratio of the tetragonal structure increased continuously in accordance with the increasing composition of x. The sample of x = 0.10 showed a similar ratio between the tetragonal and rhombohedral structures. Frequency-dependent dielectric measurements showed a sort of relaxor properties emerged with increasing x composition, this effect may be interpreted in terms of the formation of polar nano-regions (PNRs) in samples. The value of remnant polarization (Pr) decreases rapidly as x increases beyond the point of x = 0.10 from 25.3 μC/cm2 to 5.9 μC/cm2. On the contrary, as for inverse piezoelectric coefficient (d33*), a higher value of d33* (336 pm/V) at x = 0.10, was observed when compared with x = 0.05 (d33* = 51 pm/V). These results can be explained by the formation of PNRs and their variations with the external applied field. We here propose a possible mechanism showing the effects of dipolar defects, which can be resulted from the K ion substitution on (Bi,Na)TiO3 (BNT) ceramics.
1 December 2017 in Journal of the European Ceramic Society
Conventional applications of the Galvanostatic Intermittent Titration Technique (GITT) and EIS for estimating chemical diffusivity in battery electrodes face issues such as insufficient relaxation time to reach equilibrium, excessively long pulse durations that violate the short-time diffusion assumption, and the assumption of sequential electrode reaction and diffusion processes. In this work, a quasi-equilibrium criterion of 0.1 mV h−1 was applied to NMC622 electrodes, yielding 8–9 h relaxations below 3.8 V, but above 3.8 V, voltage decayed linearly and indefinitely, even upon discharging titration, showing unusual nonmonotonic relaxation behavior. The initial 36-s transients of a 10-min galvanostatic pulse and diffusion impedance in series with the electrode reaction yielded consistent diffusivity values. However, solid-state diffusion in spherical active particles within porous electrodes, where ambipolar diffusion occurs in the pore electrolyte with , requires a physics-based three-rail transmission line model (TLM). The corrected diffusivity may be three to four times higher. An analytic two-rail TLM approximating the three-rail numerical model was applied to temperature- and frequency-dependent EIS data. This approach mitigates parameter ambiguity and unphysical correlations in EIS. Physics-based EIS enables the identification of multistep energetics and the diagnosis of performance and degradation mechanisms.
Using van der Pauw method, the conductivity of disk samples of (LSM) and (LSCF) in a (GDC) matrix was accurately quasi-continuously measured over 800 °C to −73 °C, and the transition points in Arrhenius behavior were systematically obtained from the extremum points of the second derivatives. While LSM-containing samples showed reproducible conductivity trajectories, the LSCF system exhibited unsystematic changes which may be related to the substantial oxidation/reduction reactions accompanying the ferroelastic–paraelastic transitions with a substantial thermal hysteresis at 650 °C to 750 °C, corresponding to conductivity maxima. A sudden decrease in activation energies on cooling corresponds to the para-to-ferromagnetic, weak insulator–metal transitions and the Curie temperature of LSM appears to gradually decrease in composites to 90 °C, while LSCF composites exhibit blurred transitions at approximately °C. Relatively insulating paramagnetic phases are characterized by activation energy values ~0.2 eV, change to the high temperature phase exhibiting activation energy 0.1 eV for small polaron hopping mechanisms at 300 °C to 500 °C with increasing GDC content in the LSM composites and by two transitions at °C and °C for the LSCF composites. LSCF single phase shows distinctly lower transition points which appear to match with the singularly large c lattice parameter whereas the composites exhibit decreasing c with LSCF amount together with increasing lattice parameter of GDC. Van der Pauw conductivity is a feasible and sensitive in situ tool for monitoring the status of oxygen transport membranes.