A redox road to recovery: Device longevity is a key issue for organic-inorganic perovskite solar cells. Encapsulation can limit degradation arising from reactions with oxygen and water, but light, electric-field, and thermal stresses can lead to metastable elemental lead and halide atom defects. Wang et al. show that for the lead-iodine system, the introduction of the rare earth europium ion pair Eu 3+ -Eu 2+ can shuttle electrons and recover lead and iodine ions (Pb 2+ and I − ). Devices incorporating this redox shuttle maintained more than 90% of their initial power conversion efficiencies under various aging conditions. Science , this issue p. 265
Wide-bandgap (WBG) absorbers in tandem configurations suffer from poor crystallinity and weak texture, which leads to severe mixed halide-cation ion migration and phase segregation during practical operation. We control WBG film growth insensitive to compositions by nucleating the 3C phase before any formation of bromine-rich aggregates and 2H phases. The resultant WBG absorbers show improved crystallinity and strong texture with suppressed nonradiative recombination and enhanced resistance to various aging stresses. Perovskite/silicon tandem solar cells achieve power conversion efficiencies of 29.4% (28.8% assessed by a third party) in a 25–square centimeter active area and 32.5% in a 1–square centimeter active area. These solar cells retained 98.3 and 90% of the original efficiency after 1301 and 800 hours of operation at 25° and 50°C, respectively, at the maximum power point (AM 1.5G illumination, full spectrum, 1-sun) when encapsulated.
Perovskite solar cells (pero-SCs) have undergone rapid development in the past decade. However, there is still a lack of systematic studies investigating whether the empirical rules of working lifetime assessment used for silicon solar cells can be applied to pero-SCs. It is believed that pero-SCs show enhanced stability under day/night cycling owing to the reported self-healing effect in the dark1,2. Here we find that the degradation of highly efficient FAPbI3 pero-SCs is much faster under a natural day/night cycling mode, bringing into question the widely accepted approach to estimate the operational lifetime of pero-SCs based on continuous-mode testing. We reveal the key factor to be the lattice strain caused by thermal expansion and shrinking of the perovskite during operation, an effect that gradually relaxes under the continuous-illumination mode but cycles synchronously under the cycling mode3,4. The periodic lattice strain under the cycling mode results in deep trap accumulation and chemical degradation during operation, decreasing the ion-migration potential and hence the device lifetime5. We introduce phenylselenenyl chloride to regulate the perovskite lattice strain during day/night cycling, achieving a certified efficiency of 26.3 per cent and a 10-fold improvement in the time required to reach 80% of peak efficiency (T80) under the cycling mode after the modification.
Tin halide perovskites have the general chemical formula ASnX3, where A is a monovalent cation and X is a monovalent halide anion. These semiconducting materials can be used to fabricate p-type transistors at low cost and temperature and could be potentially integrated with n-type oxide-based transistors to create complementary circuits. However, the materials suffer from low crystallization controllability and high film defect density, resulting in uncompetitive device performance. Here we show that pure-tin perovskite thin-film transistors can be created using triple A cations of caesium–formamidinium–phenethylammonium. The approach leads to high-quality cascaded tin perovskite channel films with low-defect, phase-pure perovskite/dielectric interfaces. The optimized thin-film transistors exhibit hole mobilities of over 70 cm2 V−1 s−1 and on/off current ratios of over 108, which are comparable with commercial low-temperature polysilicon transistors. The transistors are fabricated using solution-processing methods at temperatures no higher than 100 °C. We also integrate the devices with n-type metal oxide transistors to create complementary inverters with voltage gains of 370, and NOR and NAND logic gates with rail-to-rail switching performance.