Beijing Key Laboratory of New Generation Photovoltaic Materials and Technology Application Key Laboratory of Polymer Chemistry and Physics of Ministry of Education State Key Laboratory of Advanced Waterproof Materials School of Materials Science and Engineering Peking University Beijing People's Republic of China
Auto-generated profile, based on publicly available information
Wentao Zhou
Beijing Key Laboratory of New Generation Photovoltaic Materials and Technology Application Key Laboratory of Polymer Chemistry and Physics of Ministry of Education State Key Laboratory of Advanced Waterproof Materials School of Materials Science and Engineering Peking University Beijing People's Republic of China
One of the primary challenges in commercializing perovskite solar cells (PSCs) is achieving both high power conversion efficiency (PCE) and sufficient stability. We integrate wafer-scale continuous monolayer MoS 2 buffers at the top and bottom of a perovskite layer through a transfer process. These films physically block ion migration of perovskite into carrier transport layers and chemically stabilize the formamidinium lead iodide phase through strong coordination interaction. Effective chemical passivation results from the formation of Pb-S bonds, and minority carriers are blocked through a type-I band alignment. Planar p-i-n PSCs (0.074 square centimeters) and modules (9.6 square centimeters) with MoS 2 /perovskite/MoS 2 configuration achieve PCEs up to 26.2% (certified steady-state PCE of 25.9%) and 22.8%, respectively. Moreover, the devices show excellent damp heat (85°C and 85% relative humidity) stability with <5% PCE loss after 1200 hours and notable high temperature (85°C) operational stability with <4% PCE loss after 1200 hours.
Wide-bandgap (WBG) absorbers in tandem configurations suffer from poor crystallinity and weak texture, which leads to severe mixed halide-cation ion migration and phase segregation during practical operation. We control WBG film growth insensitive to compositions by nucleating the 3C phase before any formation of bromine-rich aggregates and 2H phases. The resultant WBG absorbers show improved crystallinity and strong texture with suppressed nonradiative recombination and enhanced resistance to various aging stresses. Perovskite/silicon tandem solar cells achieve power conversion efficiencies of 29.4% (28.8% assessed by a third party) in a 25–square centimeter active area and 32.5% in a 1–square centimeter active area. These solar cells retained 98.3 and 90% of the original efficiency after 1301 and 800 hours of operation at 25° and 50°C, respectively, at the maximum power point (AM 1.5G illumination, full spectrum, 1-sun) when encapsulated.
The instability of perovskite solar cells (PSCs) stems largely from the formation and evolution of interfacial defects associated with the soft, multicomponent perovskite lattice. We report a scalable, plasma-based passivation strategy that forms conformal, uniform, and strong-bonded heterostructure through in situ chemical reactions on large-area perovskite films. This approach also mitigates defect accumulation within the laser-scribed interconnection regions, where localized damage often dominates module-level performance losses. We achieved a power conversion efficiency (PCE) of 27.2% in small-area devices (active area 8.313 square millimeters) and 24.0% (certified efficiency of 23.5%) in 100-square-centimeter (cm 2 ) modules (aperture area 65.05 cm 2 ). The small-area device retained 98.1% of its initial PCE after 2000 hours of maximum power point tracking at 85°C under 1-sun illumination, and the 100-cm 2 module retained 99.3% of its initial PCE after 1600 hours at 65°C under 1-sun illumination.