Saad Mulahasan

Dr. Saad Mulahasan


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 April 2021 in International Journal of River Basin Management
Verified
Journal Article
Closed access
SMSaad Mulahasan
Saad Mulahasan
MSMay Saleh
May Saleh
SASadiq Al_jilizi
Sadiq Al_jilizi
In this research, complementary numerical and experimental physical models were conducted to investigate flow parameters around an isolated permeable spur dike using ANSYS FLUENT ver. 16.1 software. The volume of fluid method VOF with the help of CFD technique and the κ−ϵ turbulence model was used to simulate the complex free-surface flow by applying a geometric reconstruction scheme. Two different medium with different porosities were used, namely, gravel and glass beads. It was found that, for low flow rates values, there are no significant changes in the water profiles in both longitudinal and lateral directions for both media. Although for high flow rates values, the differences tend to be clearer. Results showed that there is a slight effects of the medium's properties if the dike width is less than 1/3 of width of the channel, in particular with low flow rate values. Good agreement was observed between the computational and the measured results for the water surface profiles. Also, there is an exact match between the lateral velocity distribution of gravels and glass beads. Downstream the dike, the lateral velocity profiles exhibit an S shape curve due to high velocity in the free flow and small flow velocity behind the porous dike. The results show good agreement between the CFD results and the experimental observations of the water surface profiles and velocity distribution according to the statistical analysis using some standard indexes error.

5 September 2018 in E3S Web of Conferences
Verified
Conference Paper
Open access
SMSaad Mulahasan
Saad Mulahasan
TSThorsten Stoesser
Thorsten Stoesser
In this study a thermal camera was used to inferring the properties of thermal turbulent structures at the water surface of an array of emergent vertical cylindrical obstacles located in staggered fashion at one side of an open channel flow. Three different diameters (D = 1.25 cm, 2.5 cm and 5.0 cm) were tested. A thermal camera SC640 was used to record a series of snapshots of the water surface temperature distribution in the wake of the cylinders at section where the flow was uniform and fully developed. The selection was made after watching a video to locate the most suitable areas for eddies and turbulence development. For the selected location, temperature values were extracted for each sequence at five selection points in the wake region using Matlab software. Time series of temperature for the snapshots of the five selected points in the area of eddy formation were drawn. The energy of the eddies were extracted using Fourier transforms. The results showed successive peaks with a slope of - 5/3. Evaluation of the eddies in the wake of the cylindrical rods showed that the energy of the eddies is small at high frequency and large eddies were observed at low frequencies.