May Saleh

Dr. May Saleh

orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 September 2010 in Earth Surface Processes and Landforms
Verified
Journal Article
Closed access
PDF file
ACAlessandra Crosato
Alessandra Crosato
MSMay Saleh
May Saleh

31 August 2017 in Journal of Engineering
Verified
Journal Article
Open access
PDF file
RARafa H. Al-Suhaili
Rafa H. Al-Suhaili
DADheyaa W. Abbood
Dheyaa W. Abbood
MSMay Saleh
May Saleh
A model using the artificial neural networks and genetic algorithm technique is developed for obtaining optimum dimensions of the foundation length and protections of small hydraulic structures. The procedure involves optimizing an objective function comprising a weighted summation of the state variables. The decision variables considered in the optimization are the upstream and downstream cutoffs lengths and their angles of inclination, the foundation length, and the length of the downstream soil protection. These were obtained for a given maximum difference in head, depth of impervious layer and degree of anisotropy. The optimization carried out is subjected to constraints that ensure a safe structure against the uplift pressure force and sufficient protection length at the downstream side of the structure to overcome an excessive exit gradient. The Geo-studio software was used to analyze 1200 different cases. For each case the length of protection (L) and volume of structure (V) required to satisfy the safety factors mentioned previously were estimated for the input values, namely, the upstream cutoff depth (S1), the downstream cutoff depth (S2), the foundation width (B), the angle of inclination of the upstream cutoff (Ɵ1) and the angle of inclination of the downstream cutoff (Ɵ2), H (differencehead), kr (degree of anisotropy) and D (depth of impervious layer). An ANN model was developed and verified using these cases input-output sets as its data base. A MatLAB code was written to perform a genetic algorithm optimization modeling coupled with this ANN model using a formulated optimization model. A sensitivity analysis was done for selecting the crossover probability, the mutation probability and level, the number of population, the position of the crossover and the weights distribution for all the terms of the objective function. Results indicate that the most factors that affects. the optimum solution is the $ number of population required. The minimum value that gives stable global optimum solution of this parameter is (30000) while other variables have little effect on the optimum solution.

1 September 2021 in IOP Conference Series: Earth and Environmental Science
Verified
Conference Paper
Open access
SFS Fadhel
S Fadhel
MSMay Saleh
May Saleh
The rain gauge, which is the preferred device for rain rate quantification, is susceptible to various types of errors. The problems of inconsistency and incompletion of rainfall time-series, in addition to data quality issues obstruct hydrometeorological analysis. Daily rainfall data from 30 gauges in Northern England were quality controlled by a double quality check procedure for the period 2006–2014 to solve any specific data quality issues. It emerged that fault readings happened only over a few days compared with the high percentage of missing data which could reach years. Thus, factors that impact gauges’ missing data were inspected. It was found that snowfalls, land cover-land use and bird distribution are the dominant factors that malfunctioning the rain gauge for long time periods, often producing successive missing days that could be extended months in total. However, when the missing data happened on separate days, then it seemed that high winds related with light rainfall resulted in drifting away the rainfall from the rain gauge and thus caused missing data. Moreover, the rainfall itself was not one of the major factors to malfunction the gauge, because the values of missed rainfall were not quite extreme to do this.

26 August 2021 in Water
Verified
Journal Article
Open access
PDF file
SASherien Al-Azerji
Sherien Al-Azerji
Mustafa Al AukidyMustafa Al Aukidy
Mustafa Al Aukidy
MSMay Saleh
May Saleh
Most areas around the world lack fine rainfall records which are needed to derive Intensity-Duration-Frequency (IDF) curves, and those that are available are in the form of daily data. Thus, the disaggregation of rainfall data from coarse to fine temporal resolution may offer a solution to that problem. Most of the previous studies have adopted only historical rainfall data as the predictor to disaggregate daily rainfall data to hourly resolution, while only a few studies have adopted other historical climate variables besides rainfall for such a purpose. Therefore, this study adopts and assesses the performance of two methods of rainfall disaggregation one uses for historical temperature and rainfall variables while the other uses only historical rainfall data for disaggregation. The two methods are applied to disaggregate the current observed and projected modeled daily rainfall data to an hourly scale for a small urban area in the United Kingdom. Then, the IDF curves for the current and future climates are derived for each case of disaggregation and compared. After which, the uncertainties associated with the difference between the two cases are assessed. The constructed IDF curves (for the two cases of disaggregation) agree in the sense that they both show that there is a big difference between the current and future climates for all durations and frequencies. However, the uncertainty related to the difference between the results of the constructed IDF curves (for the two cases of disaggregation) for each climate is considerable, especially for short durations and long return periods. In addition, the projected and current rainfall values based on disaggregation case which adopts historical temperature and rainfall variables were higher than the corresponding projections and current values based on only rainfall data for the disaggregation.

19 April 2021 in International Journal of River Basin Management
Verified
Journal Article
Closed access
SMSaad Mulahasan
Saad Mulahasan
MSMay Saleh
May Saleh
SASadiq Al_jilizi
Sadiq Al_jilizi
In this research, complementary numerical and experimental physical models were conducted to investigate flow parameters around an isolated permeable spur dike using ANSYS FLUENT ver. 16.1 software. The volume of fluid method VOF with the help of CFD technique and the κ−ϵ turbulence model was used to simulate the complex free-surface flow by applying a geometric reconstruction scheme. Two different medium with different porosities were used, namely, gravel and glass beads. It was found that, for low flow rates values, there are no significant changes in the water profiles in both longitudinal and lateral directions for both media. Although for high flow rates values, the differences tend to be clearer. Results showed that there is a slight effects of the medium's properties if the dike width is less than 1/3 of width of the channel, in particular with low flow rate values. Good agreement was observed between the computational and the measured results for the water surface profiles. Also, there is an exact match between the lateral velocity distribution of gravels and glass beads. Downstream the dike, the lateral velocity profiles exhibit an S shape curve due to high velocity in the free flow and small flow velocity behind the porous dike. The results show good agreement between the CFD results and the experimental observations of the water surface profiles and velocity distribution according to the statistical analysis using some standard indexes error.

15 September 2020 in KSCE Journal of Civil Engineering
Verified
Journal Article
Open access
PDF file
SASadiq Al_jilizi
Sadiq Al_jilizi
MSMay Saleh
May Saleh
AQAli R. Qassim
Ali R. Qassim
In this paper the efforts were made in the laboratory to construct a physical model and a simulated model with the help of computational fluid dynamic (CFD) techniques to provide the solutions of contaminant transport within the saturated porous media under a hydraulic structure. Brinkman equations with Forchheimer correction and species flow through porous media were considered together to describe the problem. Three categories factors were considered to be analyzed in this study. The first one is the hydraulic factors represented in the upstream water head (H). While, the second factor is the geometry of the hydraulic structures represented in the length of the base and the length of the sheet pile. The physical properties and chemical properties were the third investigated factors, in which the physical properties of the porous media include porosity and intrinsic permeability, while the chemical properties represented by the rate of generation and retardation caused by the adsorption. The physical properties have a slight effect on the concentrations because of the low flow velocity through the porous media. On the other hand, a considerable decrement on the concentrations were noticed when the rate of generation and retardation caused by adsorption was increased. Also, it was observed that the diffusion coefficient has no dramatic effect on the concentrations and contaminant moving. The results of the CFD simulated model and that of the physical model were verified with two cases for pressure head and one case for the contaminates transport. For the first case of pressure head, the maximum percentage error at five selected points was about 15% at worst point with average error of 10%. While, for the case two, the maximum percentage error is about 9% at worst one with an average error of 8%. For the simulation of the contaminates transport, reliable statistical indexes error indicted that the CFD simulated model gives a good agreement with all experimental results.