The use of adsorbent heat pumps as heating and cooling systems is particularly relevant thanks to their ability to exploit low-grade heat (e.g., below 90 °C) from renewable energy sources and waste energy streams with prospective applications in several fields, e.g., industrial and residential. Their development began in the 20th century and is still in full evolution. The great interest in their improvement and optimization was determined by some key factors inherent to their sustainability compared to traditional refrigeration systems (e.g., low electricity consumption and the low environmental impact of the employed refrigerants). Recently, strong efforts have been dedicated to increasing the achievable heating/cooling power density of this technology through the development of innovative adsorbent coating technologies. Indeed, the deposition of thin coatings on the surface of the heat exchanger could reduce the heat transfer resistance existing on the adsorbent material side, thus increasing the overall adsorption dynamics. Three main approaches have been assessed, namely a thick consolidated bed, binder-based composite coatings and in situ directly crystallization coatings. This paper provides a brief overview of some of the main achievements related to adsorbent coating technology developments for adsorption heat pump applications.
A nickel ferrite was prepared by a liquid‐phase method and used as an oxygen evolution catalyst in an anion exchange membrane electrolyser. A complete physicochemical characterization of the catalyst was performed through X‐ray diffraction (XRD), Transmission electron microscopy (TEM) and X‐ray photoelectron spectroscopy (XPS). Then, the nickel ferrite was deposited by spray coating technique onto a Fumasep® FAA3‐50 anion‐exchange membrane to realize a catalyst‐coated membrane (CCM), and tested in a 5 cm2 single cell setup in the so‐called zero‐gap configuration. At 60 °C and 2.2 V, a current density of 3 A/cm2 was reached, which is higher than that obtained with NiO and IrO2 commercial catalysts. Moreover, a chronoamperometric test of 120 h highlighted the good stability of the synthesized catalyst.