After conventional forming processes, the residual stress distribution in wires is frequently unfavorable for subsequent processes, such as bending operations. High tensile residual stresses typically occur near the wire surface and normally limit further processability of the material. Additional heat treatment operations or shot peening are often used to influence the residual stress distribution in the material after conventional manufacturing, which is time- and energy-consuming. This paper presents an approach for influencing the residual stress distribution by modifying the forming process, especially regarding die geometry. The aim is to reduce the resulting tensile stress levels near the surface. Specific forming elements are integrated into the dies to achieve this residual stress reduction. These modifications in the forming zone have a significant influence on process properties, such as plastic strain and deformation direction, but typically do not influence product geometry. This paper describes the theoretical approach and model setup, the FE simulation, and the results of the experimental tests. The characterization of the residual stress states in the specimen was carried out through X-ray diffraction using the sin2Ψ method.
Forming processes are generally characterized by a high degree of material utilization as well as short process times and, consequently, a decent economic efficiency. Considering their application in the manufacturing of large spur gears, forming processes offer a significantly attractive characteristic for the production of essential gearing components commonly used in wind turbines or marine engines. Furthermore, the hot forming process can be defined as an incremental forming process which enables the use of relatively low forming forces and results in a more compact design of the used machines. These conveniences are utilized in terms of roll forming with round tools to form gears and threads in a competitive way. Based on experiences gained over many years of researching rolling technologies, a cross-rolling process characterized by round tools with outer gearings was elaborated to realize a hot forming process for gear rolling of large spur gears at the Fraunhofer IWU Chemnitz. Based on the already researched forming of smaller dimensioned gears, rolling trials utilizing a new hot-forming machinery - including defined inductive heating process before rolling - to realize large gears with outer diameters of up to 1000 millimeters were conducted. In terms of realizing this ambition, the derivation of the designated machine parameters for rolling large gears in real-life dimensions can be defined as a crucial factor. Consequently, the experimental research was followed by a mathematical analyzation of the forming forces, momenta as well as the necessary steps to determine the best possible scaling factors for the work pieces.
About Me
+ Research Eng. for Bulk Metal Forming since 2008
+ X-Ray Eng. for Residual Stress Analyses since 2013
+ Research Eng. for Bulk Metal Forming since 2008
+ X-Ray Eng. for Residual Stress Analyses since 2013