In this Letter, an ultracompact silicon-based waveguide crossing for dual polarizations is proposed and experimentally demonstrated using subwavelength-hole-assisted multimode interference couplers. Thanks to the flexible and easy dispersion engineering in the introduced subwavelength-hole-assisted multimode interference couplers, the reduced and equal beat lengths for dual polarizations are accessible via careful parametric optimization, consequently enabling a substantially reduced device size. Experimental results indicate that the proposed crossing (13.6 × 13.6 µm2 in size) features a low insertion loss of 1.03 dB (0.76 dB) and low crosstalk of –32.5 dB (–37.8 dB) at a central wavelength of 1550 nm for TE (TM) mode, with a broad bandwidth of ∼80 nm for crosstalk of <–18 dB.
We simulate and demonstrate experimentally an inner-wall grating double slot micro ring resonator (IG-DSMRR) with a center slot ring radius of only 6.72 µm based on the silicon-on-insulator platform. This novel photonic-integrated sensor for optical label-free biochemical analysis boosts the measured refractive index (RI) sensitivity in glucose solutions to 563 nm/RIU with the limit of detection value being 3.7 × 10−6 RIU (refractive index units). The concentration sensitivity for sodium chloride solutions can reach 981 pm/%, with a minimum concentration detection limit of 0.02%. Using the combination of DSMRR and IG, the detection range is enlarged significantly to 72.62 nm, three times the free spectral range of conventional slot micro ring resonators. The measured Q-factor is 1.6 × 104, and the straight strip and double slot waveguide transmission losses are 0.9 dB/cm and 20.2 dB/cm, respectively. This IG-DSMRR combines the advantages of a micro ring resonator, slot waveguide, and angular grating and is highly desirable for biochemical sensing in liquids and gases offering an ultra-high sensitivity and ultra-large measurement range. This is the first report of a fabricated and measured double-slot micro ring resonator with an inner sidewall grating structure.
In this letter, we report a new far-field polarization microscopic technique for detecting the scattering signals from a submicron particle. A diamond-like carbon submicrometer particle is imaged in terms of its scattered field intensity and polarization parameters involving the Stokes parameters. Our experimental results indicate that the proposed technique is able to resolve fine information from the anisotropic edge scattering of scatterers and also to quantitatively measure the scattered field spectra with an effective spatial range significantly extending beyond the conventional microscopy.
To further increase the transmission capacity of on-chip optical communication systems, hybrid division multiplexing technology has emerged as a crucial alternative solution, in which multimode waveguide crossings are highly desired. In this paper, we propose and experimentally demonstrate a compact multimode (i.e., three different modes) waveguide crossing that employs subwavelength holey metamaterial waveguides (SHMWs). The used SHMW, formed by inserting subwavelength periodic holes into a multimode interference (MMI) coupler, deservedly exhibits synergetic advantages of the two kinds of structures, enabling an attractive three-mode (e.g., TE0, TM0, and TM1) waveguide crossing with flexible design, small size, and good performance. Simulation results show that the realized device has a low insertion loss (< 0.74 dB), low reflection loss (<−13.1 dB), and low crosstalk (<−31.6 dB) at a central wavelength of 1550 nm for all the modes with a compact footprint of 27.4 µm × 27.4 µm. The experimental results prove that insertion losses are as low as 0.72 dB, 0.27 dB, and 0.90 dB for TE0, TM0, and TM1 mode, respectively, with the corresponding crosstalk below −38 dB at 1550 nm. The proposed device can be widely applied in photonic integrated circuits to construct photonic systems with the abilities of mode control and multiplexing.
A stroboscopic full-field imaging technique based on photorefractive interferometry for the visualization of rapidly changing surface displacement fields by using of a standard charge-coupled device (CCD) camera is presented. The photorefractive buildup of the space charge field during and after probe laser pulses is simulated numerically. The resulting anisotropic diffraction upon the refractive index grating and the interference between the polarization-rotated diffracted reference beam and the transmitted signal beam are modeled theoretically. The method is experimentally demonstrated by full-field imaging of the propagation of photoacoustically generated surface acoustic waves with a temporal resolution of nanoseconds. The surface acoustic wave propagation in a 23 mm × 17 mm area on an aluminum plate was visualized with 520 × 696 pixels of the CCD sensor, yielding a spatial resolution of 33 μm. The short pulse duration (8 ns) of the probe laser yields the capability of imaging SAWs with frequencies up to 60 MHz.