In the surface filtration process with pores larger than the particle size, the formation of particle bridges plays a crucial role in the filter cake structure and the filtration efficiency throughout the filtration process. First, to understand the microscopic information required for the bridging mechanism, we use the two-way coupling of computational fluid dynamics (CFD)–discrete element method (DEM) to simulate the deposition characteristics of particles in the pores of ceramic membranes. Next, by dynamically observing the deposition morphology and bridging process of particles, the bridging mechanism was revealed at the level of a single hole. Then, we studied the influence of particle concentration and inlet velocity on the bridge erection process. The results show that the bridging function of particles runs through the clean filtration stage and the transition stage. Particle concentration and inlet flow rate have a crucial influence on the formation of particle bridges and filtration efficiency.
The discrete element method coupled with the computational fluid dynamic (CFD-DEM) method is effective for studying the micro-flow process of lignin particles in ceramic membranes. Lignin particles may exhibit various shapes in industry, so it is difficult to model their real shapes in CFD-DEM coupled solutions. Meanwhile, the solution of non-spherical particles requires a very small time-step, which significantly lowers the computational efficiency. Based on this, we proposed a method to simplify the shape of lignin particles into spheres. However, the rolling friction coefficient during the replacement was hard to be obtained. Therefore, the CFD-DEM method was employed to simulate the deposition of lignin particles on a ceramic membrane. Impacts of the rolling friction coefficient on the deposition morphology of the lignin particles were analyzed. The coordination number and porosity of the lignin particles after deposition were calculated, based on which the rolling friction coefficient was calibrated. The results indicated that the deposition morphology, coordination number, and porosity of the lignin particles can be significantly affected by the rolling friction coefficient and slightly influenced by that between the lignin particles and membranes. When the rolling friction coefficient among different particles increased from 0.1 to 3.0, the average coordination number decreased from 3.96 to 2.73, and the porosity increased from 0.65 to 0.73. Besides, when the rolling friction coefficient among the lignin particles was set to 0.6–2.4, the spherical lignin particles could replace the non-spherical particles.
17 May 2022 in Mathematical Problems in Engineering
The optical window is an essential channel for optical signal transmission and return of a deep-sea hydrothermal velocimetry system. Due to its unique structural design, the stress concentration of the optical window will occur under the action of deep-sea high pressure, resulting in cracks at the corner of the high-pressure surface of the optical window, which leads to the inaccurate convergence of the optical signal. A pressure self-balancing optical window package structure is designed to solve the problem. The stress at the optical window is numerically analyzed, and the forces of self-balancing and nonpressure self-balancing optical windows under the same seawater pressure are compared. The results show that the maximum stress at the stress concentration can be reduced by 53% using the pressure self-balancing method, and the phenomenon of stress concentration can be effectively eliminated. In addition, to verify the feasibility of the design and the accuracy of the numerical calculation results, the optical window and its encapsulation structure were experimentally studied, and the deep-sea performance test experiment was carried out on the “Jiaolong” submersible, which further verified the accuracy of the results.