ZnS:Mn nanocrystals thin film was fabricated at 300°C and 500°C via the spin coating method. Its sol-gel was spin coated for 20 s at 3000 rpm and 4000 rpm with metal tape being used to mold the shape of the thin film. A different combination of these parameters was used to investigate their influences on the fabrication of the film. Optical and structural characterizations have been performed. Optical characterization was analyzed using UV-visible spectroscopy and photoluminescence spectrophotometer while the structural and compositional analysis of films was measured via field emission scanning electron microscopy and energy dispersive X-ray. From UV-vis spectra, the wavelength of the ZnS:Mn was 250 nm and the band gap was within the range 4.43 eV–4.60 eV. In room temperature PL spectra, there were two emission peaks centered at 460 nm and 590 nm. Under higher annealing temperature and higher speed used in spin coating, an increase of 0.05 eV was observed. It was concluded that the spin coating process is able to synthesize high quality spherical ZnS:Mn nanocrystals. This conventional process can replace other high technology methods due to its synthesis cost.
The structure of macrobending fiber optics is an ideal structure for constructing fiber optic sensors. This study presents a new design and implementation of U-shaped fiber optics. The basic geometric parameters of U-shaped fiber optics, such as dimension size or curve radius, are analyzed. The Taguchi method was used to optimize the effects of the control and noise factors with respect to dimension size, loop, wavelength, and core size. The control factors were varied at different levels to achieve a novel sensitivity response optimization of the wavelength and core size. The quality characteristics of the signal-to-noise ratio (larger-the-better characteristics) were used to determine the effect of the control parameters in the data analysis. The data of the sensitivity response was analyzed to predict the performance of the U-shaped fiber optics. Results indicate that, by using the Taguchi method, the best control factor setting involves 2.5 cm × 1.5 cm (dimension size) and 1550 nm (wavelength). The percentage contribution of wavelength is the highest at 67.17%, followed by dimension size (13.31%) and number of loops (11.72%) for the fiber optic core size of 50–9–50 μm. For the 9 μm single-mode fiber optics, the corresponding percentages are 61.48%, 16.64%, and 12.81% for wavelength, dimension size, and number of loops, respectively. The Taguchi methodology is suitable for designing sensor geometry.
Optical fibers with high sensitivity are in demand due to their great potential in sensor application. Semiconductors, such as ZnO, are good materials. Using them as a second cladding offers opportunities in realizing next-generation multimaterial fiber optics. COMSOL Multiphysics is used to simulate heterocore macrobend fiber optics with the same curvature radius but different values of refractive index and thickness of ZnO films. The optimum thickness of ZnO films is identified by determining the loss of optical fibers. Macrobend heterocore fiber optics by adding ZnO thin film has been established by simulating and interpreting the relationship in terms of transmission and refractive index in the evanescent field. These results will provide a reliable fundamental to guide the performance in practice.
1 August 2011 in American Journal of Applied Sciences