Recently, rechargeable aluminum batteries have received much attention due to their low cost, easy operation, and high safety. As the research into rechargeable aluminum batteries with a room-temperature ionic liquid electrolyte is relatively new, research efforts have focused on finding suitable electrode materials. An understanding of the environmental aspects of electrode materials is essential to make informed and conscious decisions in aluminum battery development. The purpose of this study was to evaluate and compare the relative environmental performance of electrode material candidates for rechargeable aluminum batteries with an AlCl3/EMIMCl (1-ethyl-3-methylimidazolium chloride) room-temperature ionic liquid electrolyte. To this end, we used a lifecycle environmental screening framework to evaluate 12 candidate electrode materials. We found that all of the studied materials are associated with one or more drawbacks and therefore do not represent a “silver bullet” for the aluminum battery. Even so, some materials appeared more promising than others did. We also found that aluminum battery technology is likely to face some of the same environmental challenges as Li-ion technology but also offers an opportunity to avoid others. The insights provided here can aid aluminum battery development in an environmentally sustainable direction.
Sulfide‐based solid electrolytes (SEs) are amongst the most promising solid electrolytes for the development of solid‐state batteries (SSBs) due to their high ionic conductivity and processing advantage over oxide‐based SEs. However, one of the main drawbacks of sulfide SEs is their rapid degradation in presence of humidity. In this study, we investigated the effect of exposing three different sulfide SEs (Li7P3S11, the argyrodite Li6PS5Cl and the chloride‐doped argyrodite Li6‐xPS5‐xCl1+x) to the atmosphere of a dry room at a dew point (DP)=−40 °C. For the first time to the best of our knowledge, enhanced infra‐red (IR) laser technology was employed to follow and quantify online and in‐situ H2S evolution by the SEs in a dry room environment over 16 h. It was found that argyrodite compounds evolved approximately 8 times less H2S compared to Li7P3S11 over 16 h of exposure with peak concentrations between 5 and 16 ppm vol. The exposed materials were studied using X‐ray diffraction, Raman spectroscopy, electrochemical impedance spectroscopy, X‐ray photoelectron spectrometry (XPS) and galvanostatic cycling. XPS results revealed a formation of Li2CO3 on the surface of argyrodite SEs, which served as a robust passivation layer limiting considerably reactions with the dry room atmosphere.
1 January 2011 in Journal of the Electrochemical Society
In this article, we investigate hysteresis behavior observed in the current-voltage transfer curve of regioregular poly(3-hexylthiophene)(P3HT) based thin film transistors (PTFTs) using bi-directional voltage sweeping. According to the results of our experiments, the hysteresis effects were closely related to oxygen (O2) and water (H2O) molecules residing in the P3HT active layer. As a result, we hypothesized that O2 and H2O in the P3HT could form two kinds of dopants, i.e., stable and transient states. Stable state dopants, which are commonly thought to be of the acceptor-type dopants, could induce holes in the channel region contributing to better on-current. On the contrary, transient state dopants were found to be unable to induce holes, however could enable the formation of polarization agents and create hysteresis. These two types of dopants seem have a common origin, thus they could be converted into each other through the combination of specific processes and applied external bias. From the viewpoint of device operation stability, except on-current level and characteristics including threshold voltage, off-current magnitude and on/off ratio, the impact of hysteresis should garner the attention of those pursuing high performance PTFTs.