This paper presents the feasibility of a fully inkjet-printed, microwave flexible gas sensor based on a resonant electromagnetic transducer in microstrip technology and the impact of the printing process that affects the characteristics of the gas sensor. The sensor is fabricated using silver ink and multi-wall carbon nanotubes (MWCNTs) embedded in poly (3,4-ethylenedioxythiophene) polystyrene (PEDOT: PSS-MWCNTs) as sensitive material for Volatile Organic Compounds (VOCs) detection. Particular attention is paid to the characterization of the printed materials and the paper substrate. The manufacturing process results in a change in relative permittivity of the paper substrate by nearly 20%. Electrical characterization, made in the presence of gas, validates our theoretical approach and the radiofrequency (RF) gas sensor proof of concept.
18 April 2018 in IEEE Transactions on Nanotechnology
This paper presents the feasibility of a low-cost fully inkjet printed capacitive microwave flexible gas sensor based on a resonant electromagnetic transducer in micro-strip technology with poly (3,4-ethylenedioxythiophene) polystyrene sulfonate and multi wall carbon nanotubes (PEDOT:PSS-MWCNTs) as sensitive material for Volatile Organic Compounds (VOCs) detection. The design and simulation results of the device on paper substrate for differential measurements are first described. This theoretical study based on both analytical and Finite Element Model approaches, validates the operating principle. The fabrication process and experimental devices are then presented, as well as electrical characterization results, both in air and under selected vapor analytes. These experimental results show the good sensor repeatability and sensitivity according to the transmission S parameter resonant frequency shift equal to -2.153 kHz/ppm and -1.855 kHz/ppm for ethanol and toluene vapor concentrations from 500 to 1300 ppm, respectively. This leads to conclude on promising future of such passive sensors and further integration into real-time multi-sensing platform adaptable for the Internet of Things (IoT).
This communication presents results on the feasibility of an inkjet printed chemical gas sensor suitable for a real time multi-sensing platform. The prototype targets volatile organic compounds (VOCs) such as ethanol vapor to monitor environmental pollution. The designed and ink-jet printed microwave sensor is presented. Preliminary results have shown the influence of ethanol vapor on the electrical properties of the sensor at microwave frequency range. The sensor’s sensitivity to ethanol vapor has been estimated to −2.48 kHz/ppm. The final aim of this work is to develop a low cost sensor for Internet of Things (IoT) applications.