The iron–chromium redox flow battery (ICRFB) has a wide range of applications in the field of new energy storage due to its low cost and environmental protection. Graphite felt (GF) is often used as the electrode. However, the hydrophilicity and electrochemical activity of GF are poor, and its reaction reversibility to Cr3+/Cr2+ is worse than Fe2+/Fe3+, which leads to the hydrogen evolution side reaction of the negative electrode and affects the efficiency of the battery. In this study, the optimal composite modified GF (Bi-Bio-GF-O) electrode was prepared by using the optimal pomelo peel powder modified GF (Bio-GF-O) as the matrix and further introducing Bi3+. The electrochemical performance and material characterization of the modified electrode were analyzed. In addition, using Bio-GF-O as the positive electrode and Bi-Bio-GF-O as the negative electrode, the high efficiency of ICRFB is realized, and the capacity attenuation is minimal. When the current density is 100 mA·cm−2, after 100 cycles, the coulomb efficiency (CE), voltage efficiency (VE), and energy efficiency (EE) were 97.83%, 85.21%, and 83.36%, respectively. In this paper, the use of pomelo peel powder and Bi3+ composite modified GF not only promotes the electrochemical performance and reaction reversibility of the negative electrode but also improves the performance of ICRFB. Moreover, the cost of the method is controllable, and the process is simple.
Surface passivation, which has been intensively studied recently, is essential for the perovskite solar cells (PSCs), due to the intrinsic defects in perovskite crystal. A series of chemical or physical methods have been published for passivating the defects of perovskite, which effectively suppressed the charge recombination and enhanced the photovoltaic performance. In this study, the n-type semiconductor of [6,6]-phenyl-C61-butyric acid methyl ester (PCBM) is dissolved in chlorobenzene (CB) for the surface passivation during the spin-coating process for depositing the two-dimensional (2D) perovskite film. This approach simplifies the fabrication process of 2D PSCs and benefits the film quality. As a result, the defects of perovskite film are effectively passivated by this method. A better perovskite/PCBM heterojunction is generated, exhibiting an increased film coverage and improved film morphology of PCBM. It is found that this technology results in an improved electron transporting performance as well as suppressed charge recombination for electron transport layer. As a result, PSCs based on the one-step formed perovskite/PCBM heterojunctions exhibit the optimized power conversion efficiency of 15.69% which is about 37% higher than that of regular perovskite devices. The device environmental stability is also enhanced due to the quality-improved electron transport layer.