Lam Nguyen Luong

Dr. Lam Nguyen Luong


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 November 2021 in Water
Verified
Journal Article
Open access
PDF file
LTLe Phuong Thu
Le Phuong Thu
DLDuy Ngoc Le
Duy Ngoc Le
TNThi Hue Nguyen
Thi Hue Nguyen
HBHuyen Thuong Bui
Huyen Thuong Bui
APAnh Le Pham
Anh Le Pham
TDThi Mai Thanh Dinh
Thi Mai Thanh Dinh
In this study, titanium dioxide (TiO2) nanoparticles are immobilized onto rice husk biochar (RHB), as a porous support, for the photodegradation of glyphosate under UV light irradiation. The TiO2/RHB composites are prepared by pyrolysis and the sol-gel method. The SEM, XRD, EDX, and FT-IR results confirm the graphene structure of RHB and the formation of 10.61 nm TiO2 nanoparticles on the catalyst support. The effects of operating conditions, including catalyst dosage (3 g L−1, 5 g L−1, 10 g L−1, and 20 g L−1) and different illumination conditions (9 W lamp, 2 × 9 W lamps), on the removal of glyphosate from aqueous solutions were investigated. The photodegradation efficiency of 15 mg L−1 of commercial glyphosate was up to 99% after 5 h of irradiation at pH 3.0, with a TiO2/RHB dosage of 10 g L−1. However, the mineralization efficiency under this condition was lower than the decomposition efficiency of glyphosate, proving the partial degradation of glyphosate into AMPA and other metabolites after 5 h of reaction.

29 July 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
LLLam Nguyen Luong
Lam Nguyen Luong
Hai LEHai LE
Hai LE
VPVan Nhat Pham
Van Nhat Pham
MBMathieu Bastide
Mathieu Bastide
SGSarra Gam-Derouich
Sarra Gam-Derouich
JLjean christophe lacroix
jean christophe lacroix
This paper describes a rapid bottom-up approach to selectively functionalize gold nanoparticles (AuNPs) on an indium tin oxide (ITO) substrate using the plasmon confinement effect. The plasmonic substrates based on a AuNP-free surfactant were fabricated by electrochemical deposition. Using this bottom-up technique, many sub-30 nm spatial gaps between the deposited AuNPs were randomly generated on the ITO substrate, which is difficult to obtain with a top-down approach (i.e., E-beam lithography) due to its fabrication limits. The 4-Aminodiphenyl (ADP) molecules were grafted directly onto the AuNPs through a plasmon-induced reduction of the 4-Aminodiphenyl diazonium salts (ADPD). The ADP organic layer preferentially grew in the narrow gaps between the many adjacent AuNPs to create interconnected AuNPs. This novel strategy opens up an efficient technique for the localized surface modification at the nanoscale over a macroscopic area, which is anticipated to be an advanced nanofabrication technique.

31 July 2025 in Polymers
Verified
Journal Article
Open access
PDF file
TDThai Anh Do
Thai Anh Do
LLLam Nguyen Luong
Lam Nguyen Luong
NKNguyen Thi Thuy Khue
Nguyen Thi Thuy Khue
VNVan Quyen Nguyen
Van Quyen Nguyen
In this study, we report an effective, one-step chemical treatment to directly isolate carboxylated cellulose nanocrystals (CCNCs) from a lignocellulosic source using a mixture of peracetic acid and 10% H2SO4 solution. We used infrared spectroscopy, X-ray diffraction, dynamic light scattering, atomic force microscopy, and scanning electron microscopy to characterize all the materials. The obtained CCNCs exhibited needle-like shapes with a width of 10–50 nm and a length of 200–500 nm, a high crystalline index (71.3%), and a high content of -COOH groups (~1.405 mmol/g), with a zeta potential value of −48.5 mV. We attributed this to the cooperative effect of strong oxidative agent and strong acid, which makes the removal of all components occur simultaneously in parallel with the partial hydrolysis of amorphous cellulose regions. Our study opens a new, simple approach to directly isolate cellulose nanocrystals from a lignocellulosic source.