In this work, the novel hybrid nanomaterial SWCNT/SiPc made of single walled carbon nanotubes (SWCNT) cross-linked via axially substituted silicon (IV) phthalocyanine (SiPc) was studied as the active layer of chemiresistive layers for the detection of ammonia and hydrogen. SWCNT/SiPc is the first example of a carbon-based nanomaterial in which an axially substituted phthalocyanine derivative is used as a linker. The prepared hybrid material was characterized by spectroscopic methods, thermogravimetry, scanning and transmission electron microscopies. The layers of the prepared hybrid were tested as sensors toward ammonia and hydrogen by a chemiresistive method at different temperatures and relative humidity as well as in the presence of interfering gases like carbon dioxide, hydrogen sulfide and volatile organic vapors. The hybrid layers exhibited the completely reversible sensor response to both gases at room temperature; the recovery time was 100–200 s for NH3 and 50–120 s in the case of H2 depending on the gas concentrations. At the relative humidity (RH) of 20%, the sensor response was almost the same as that measured at RH 5%, whereas the further increase of RH led to its 2–3 fold decrease. It was demonstrated that the SWCNT/SiPc layers can be successfully used for the detection of both NH3 and H2 in the presence of CO2. On the contrary, H2S was found to be an interfering gas for the NH3 detection.
Films of zinc phthalocyanines with alkylthio (–S(CH 2 ) 5 CH 3 ) and polyoxo (O(CH 2 CH 2 O) 3 CH 3 and –S(CH 2 CH 2 O) 3 CH 3 ) substituents, exhibiting liquid crystalline properties, were tested as active layers of chemiresistive sensors for the detection of ammonia.
Quantum chemical calculations of the geometric and electronic structure of periodic hybrid compounds representing carbon nanotubes (10,0) with zinc phthalocyanine molecules ZnPc-xpy (x = 0, 1, 2, 4) on their surface and their interaction with ammonia were carried out to explain the dependence of the sensor response of the hybrid materials to ammonia on the number of substituents in the ZnPc-xpy macrocycle and to clarify the nature of the interaction between ammonia and phthalocyanine molecules. It was found that the key feature of these materials, which determines their sensor response toward ammonia, is the presence of an impurity band in the band gap of a carbon nanotube, formed by the orbitals of macrocycle atoms. When ammonia adsorbs through the formation of hydrogen bonds with the side atoms of phthalocyanine, the energy of this impurity band decreases. As a consequence, the electron population of the conduction band and, accordingly, the electrical conductivity of the hybrid materials become lower. Moreover, with an increase in the number of oxypyrene substituents in ZnPc-xpy, the interaction energy of ammonia increases and, as a result, the decrease in the energy of the impurity band becomes higher. These facts may explain recent experimental measurements of the parameters of the sensor response of similar hybrid materials to ammonia, where, in particular, it was shown that the sensor response is reversible, and its value increases with an increase in the number of oxypyrene substituents in the phthalocyanine macrocycle.
Si(IV)Pc derivatives bearing two –O(CH2CH2O)3CH3 substituents in axial positions (SiPc-1) and four (SiPc-2) or eight (SiPc-3) –O(CH2CH2O)3CH3 substituents on the phthalocyanine ring were investigated to reveal the effect of position and number of substituents on the orientation and chemiresistive sensor response of their films to ammonia. The liquid crystalline behavior of the Si(IV)Pc derivatives was studied using differential scanning calorimetry and polarizing optical microscopy. Only the SiPc-3 derivative was found to exhibit a mesophase over a wide temperature range, identified as a discotic columnar hexagonal (Colh) phase. The orientation of SiPc films prepared by spin coating was determined by polarized Raman spectroscopy. SiPc-1 formed crystalline films with a preferential orientation of phthalocyanine macrocycles relative to the substrate surface, with the inclination angle of approximately 65°. SiPc-2 films, on the other hand, were disordered. The introduction of eight triethylene glycol-substituents into SiPc-3 resulted in a change in the film orientation, with the macrocycles oriented parallel to the substrate surface. SiPc-3 films exhibited the best chemiresistive sensor response to ammonia, with a detection limit of 100 ppb and low response and recovery times.
This paper presents the results of quantum-chemical modeling performed by the Density Functional-Based Tight Binding (DFTB) method to investigate the change in the band structure of hybrid materials based on carbon nanotubes and unsubstituted, tetra-, or octa-halogen-substituted zinc phthalocyanines upon the adsorption of ammonia molecules. The study showed that the electrical conductivity of these materials and its changes in the case of interaction with ammonia molecules depend on the position of the impurity band formed by the orbitals of macrocycle atoms relative to the forbidden energy gap of the hybrids. The sensor response of the hybrids containing halogenated phthalocyanines was lower by one or two orders of magnitude, depending on the number of substituents, compared to the hybrid with unsubstituted zinc phthalocyanine. This result was obtained by calculations performed using the nonequilibrium Green’s functions (NEGF) method, which demonstrated a change in the electrical conductivity of the hybrids upon the adsorption of ammonia molecules. The analysis showed that in order to improve the sensor characteristics of CNT-based hybrid materials, preference should be given to those phthalocyanines in which substituents contribute to an increase in HOMO energy relative to the unsubstituted macrocycles.