The first fully integrated receiver based on single-photon avalanche diodes (SPADs) for data rates of up to 200 Mb/s is reported . An array of four SPADs in combination with quenching circuits and a short dead time of 3.5 ns is fabricated in a 0.35 μm CMOS process. The responses of the SPADs are combined using an integrated digital latch-type processing circuit to create a single output data stream. In addition, the output of each quenching circuit is recorded and the bit error rates are extracted by postprocessing in MATLAB. Using a 635-nm single-mode laser source, the bit error rate at different optical power is measured at 50, 100, 150, and 200 Mb/s. The integrated digital circuit achieved the best sensitivity at –46.3 dBm (BER = 2·10 –3 ) for 100 Mb/s. Using the MATLAB postprocessing, a sensitivity of –43.8 dBm at 200 Mb/s (BER = 6.5·10 –3 ) is reached.
In this Letter, we describe the realization of a tracked line-of-sight optical wireless communication system for indoor data distribution. We built a laser-based transmitter with adaptive focus and ray steering by a microelectromechanical systems mirror. To execute the alignment procedure, we used a CMOS image sensor at the transmitter side and developed an algorithm for image recognition to localize the receiver’s position. The receiver is based on a self-developed optoelectronic integrated chip with low requirements on the receiver optics to make the system economically attractive. With this system, we were able to set up the communication link automatically without any back channel and to perform error-free (bit error rate ) data transmission over a distance of 3.5 m with a data rate of 3 Gbit/s.
A novel monolithically integrated optoelectronic receiver with a 200 µm diameter, high responsivity avalanche photodiode (PD) is presented. The whole receiver was developed in a high‐voltage 0.35 µm CMOS technology. This permits high PD bias voltages and the implementation of the receiver circuitry in a single chip. With a PD bias voltage of 65 V, a high responsivity of 30 A/W has been reached at a wavelength of 675 nm. Together with a folded‐cascode transimpedance amplifier, the complete receiver achieves a sensitivity of −31.8 dBm at a data rate of 1 Gbit/s with a bit error rate of 10 −9 and a pseudorandom binary sequence of 2 31 –1.
An optoelectronic integrated circuit in a 0.35 µm BiCMOS technology containing a 200 µm diameter pin photodiode for optical wireless communication systems is presented. The design consists of a highly efficient integrated Si pin photodiode, a transimpedance amplifier and 50 Ω output driver. The overall transimpedance of the whole receiver is 86.6 dBΩ. At a data rate of 3 Gbit/s with a pseudorandom bit sequence of 2 31 − 1 a sensitivity of − 23.4 dBm is achieved (BER = 10 − 9 , λ = 675 nm).
15 January 2014 in Transactions on Emerging Telecommunications Technologies