Most areas around the world lack fine rainfall records which are needed to derive Intensity-Duration-Frequency (IDF) curves, and those that are available are in the form of daily data. Thus, the disaggregation of rainfall data from coarse to fine temporal resolution may offer a solution to that problem. Most of the previous studies have adopted only historical rainfall data as the predictor to disaggregate daily rainfall data to hourly resolution, while only a few studies have adopted other historical climate variables besides rainfall for such a purpose. Therefore, this study adopts and assesses the performance of two methods of rainfall disaggregation one uses for historical temperature and rainfall variables while the other uses only historical rainfall data for disaggregation. The two methods are applied to disaggregate the current observed and projected modeled daily rainfall data to an hourly scale for a small urban area in the United Kingdom. Then, the IDF curves for the current and future climates are derived for each case of disaggregation and compared. After which, the uncertainties associated with the difference between the two cases are assessed. The constructed IDF curves (for the two cases of disaggregation) agree in the sense that they both show that there is a big difference between the current and future climates for all durations and frequencies. However, the uncertainty related to the difference between the results of the constructed IDF curves (for the two cases of disaggregation) for each climate is considerable, especially for short durations and long return periods. In addition, the projected and current rainfall values based on disaggregation case which adopts historical temperature and rainfall variables were higher than the corresponding projections and current values based on only rainfall data for the disaggregation.
Sediment accumulates behind dams, thereby reducing their operational efficiency. In response to this issue, hydraulic flushing is considered an effective solution for its removal. A numerical model is used to provide a deep understanding of this process and its dynamics. It acts as a low-cost virtual laboratory that eliminates the need for costly field experiments and provides a precise understanding of sedimentation and flushing behavior. This study used numerical modeling to examine sediment deposition in the Tigris River upstream of the Samarra Barrage. Within the iRIC framework, two models were used: NaysCUBE and Nays2DH. NaysCUBE is a three-dimensional solver that provides detailed simulations of partial gate openings and vertical flow distribution. This capability is crucial for a realistic analysis of the flushing process. Nays2DH is a two-dimensional solver that simulates full gate openings and captures general flow patterns. Results showed that sediment deposits were mostly concentrated within the first kilometer upstream of the dam, particularly when backwater effects caused the outflow to be lower than the inflow. Different gate operation schemes produced varied results: some configurations improved the balance between sediment movement and water flow, whereas others caused local erosion and uneven scouring. Results showed that lowering the water level at the barrage by 1 m increases shear stress on the riverbed by up to 25%, thereby improving the river’s ability to carry sediment without the need for additional discharge. High-discharge flushing operations are no longer feasible because of the reduced flow in the Tigris River since the operation of the Ilisu Dam in Turkey. This study recommends maintaining low water levels at the barrage with frequent and reasonable maintenance operations by partially opening the gates (40–60%). This strategy maintains a balance between the required water storage and sediment control, thereby ensuring the long-term sustainability of the hydraulic structure and the river ecosystem.