Chaehwan Jeong

Dr. Chaehwan Jeong

orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 May 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
JLJeong Hyuk Lee
Jeong Hyuk Lee
BLByeong Hyeon Lee
Byeong Hyeon Lee
JKJeonghun Kang
Jeonghun Kang
Mangesh DiwareMangesh Diware
Mangesh Diware
KJKiseok Jeon
Kiseok Jeon
Kee Hoon KimKee Hoon Kim
Kee Hoon Kim
Transparent p-CuI/n-SiZnSnO (SZTO) heterojunction diodes are successfully fabricated by thermal evaporation of a (111) oriented p-CuI polycrystalline film on top of an amorphous n-SZTO film grown by the RF magnetron sputtering method. A nitrogen annealing process reduces ionized impurity scattering dominantly incurred by Cu vacancy and structural defects at the grain boundaries in the CuI film to result in improved diode performance; the current rectification ratio estimated at ±2 V is enhanced from ≈106 to ≈107. Various diode parameters, including ideality factor, reverse saturation current, offset current, series resistance, and parallel resistance, are estimated based on the Shockley diode equation. An energy band diagram exhibiting the type-II band alignment is proposed to explain the diode characteristics. The present p-CuI/n-SZTO diode can be a promising building block for constructing useful optoelectronic components such as a light-emitting diode and a UV photodetector.

1 May 2010 in Journal of Nanoscience and Nanotechnology
Verified
Journal Article
Closed access
CJChaehwan Jeong
Chaehwan Jeong
YKYoung-Baek Kim
Young-Baek Kim
SLSuk-Ho Lee
Suk-Ho Lee
JCJu H. Choi
Ju H. Choi
Hydrogenated amorphous silicon carbide (a-SiC:H) film has been widely used as an emitter p layer in solar cells. For the better p layer, wide optical bandgap, and high electrical conductivity should be obtained from the effective method. We prepared the boron-doped a-SiC:H thin films using inductively coupled plasma chemical vapor deposition (ICP-CVD) method and characteristics on the small-area (2 cm x 2 cm) as well as the large-area films (diameter of 100 mm) were shown on it. As a substrate, the n-type (100) oriented CZ c-Si (5.5 approximately 6.5 omega x cm, 650 microm) wafers were used and cleaned by using the reduced RCA method. A silane (SiH4) of 99.999% purity, H2 and 60% hydrogen diluted ethylene (C2H4) was used as source gas for the deposition of intrinsic a-SiC:H films, and then diborane (B2H6), as the doping gas, is added to C2H4 and SiH4/H2 during the deposition of films. The uniformity of thickness and optical bandgap from large-area as-dep. films was at 1.8% and 0.3%, respectively. Heterojunction solar cell with 2 wt%-AZO/p-a-SiC:H/i-a-Si:H/c-Si/Ag structure was fabricated and characterized with diameter of 152.3 mm in this large-area ICP-CVD system. Conversion efficiency of 9.123% was achieved with a practical area of 100 mm x 100 mm, which can show the potentials to the fabrication of the large-area solar cell using ICP-CVD method.

16 July 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Hongsub JeeHongsub Jee
Hongsub Jee
MPMin-Joon Park
Min-Joon Park
KJKiseok Jeon
Kiseok Jeon
CJChaehwan Jeong
Chaehwan Jeong
Jaehyeong LeeJaehyeong Lee
Jaehyeong Lee
Interference lithography is a promising method for fabricating large-area, defect-free three-dimensional photonic crystal structures which can be used for facilitating the realization of photonic devices with a fast processing time. Although they can be used in waveguides, resonators, and detectors, their repeated regular array patterns can only be used for limited applications. In this study, we demonstrate a method for fabricating large-area photonic crystal structures with controlled defects by combining interference lithography and two-photon lithography using a light-curable resin. By combining regular array structures and controlled patterns, monotonous but large-area regular structures can be obtained. Furthermore, the patterned structures have considerable potential for use in various applications, such as solar cells, sensors, photodetectors, micro-/nano-electronics, and cell growth.

1 June 2015 in Solar Energy
Verified
Journal Article
Closed access
CKChangheon Kim
Changheon Kim
JLJonghwan Lee
Jonghwan Lee
SLSangwoo Lim
Sangwoo Lim
CJChaehwan Jeong
Chaehwan Jeong

1 April 2020 in Applied Surface Science
Verified
Journal Article
Closed access
WOWonje Oh
Wonje Oh
JPJisu Park
Jisu Park
CJChaehwan Jeong
Chaehwan Jeong
JPJinhong Park
Jinhong Park
JYJunsin Yi
Junsin Yi
JLJaehyeong Lee
Jaehyeong Lee

1 August 2018 in Thin Solid Films
Verified
Journal Article
Closed access
KJKiseok Jeon
Kiseok Jeon
HJHongsub Jee
Hongsub Jee
MPMin Joon Park
Min Joon Park
SLSangwoo Lim
Sangwoo Lim
CJChaehwan Jeong
Chaehwan Jeong