Mihael Bucko

Dr. Mihael Bucko

orcid

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 July 2021 in Molecules
Verified
Journal Article
Open access
PDF file
MRMarija Ridjosic
Marija Ridjosic
MBMihael Bucko
Mihael Bucko
ASAsier Salicio-Paz
Asier Salicio-Paz
Eva Garcia-LecinaEva Garcia-Lecina
Eva Garcia-Lecina
LŽLjiljana S. Živković
Ljiljana S. Živković
JBJelena Bajat
Jelena Bajat
Novel Zn-Co-CeO2 protective composite coatings were deposited successfully from chloride plating solutions. Two different types of ceria sources were used and compared: commercial ceria powder and home-made ceria sol. Electrodeposition was performed by a direct current in the range of 1–8 A dm−2. Two different agitation modes were used and compared, magnetic stirring and ultrasound-assisted stirring (US). The influence of magnetic stirring on the stability of the related plating baths was evaluated via a dynamic scattering method. The results pointed to better stability of the prepared ceria sol. The morphology of the composite coatings was examined by scanning electron microscopy (SEM), and particle content was determined by energy-dispersive X-ray spectroscopy (EDS). The results showed that the increase in the deposition current density was not beneficial to the coating morphology and particle content. The corrosion behavior of the Zn-Co-CeO2 composite coatings was analyzed and compared by electrochemical impedance spectroscopy and polarization resistance. The ultrasound-assisted electrodeposition at small current densities was favorable for obtaining composite coatings with enhanced corrosion stability. The protection was more effective when US was applied and, additionally, upon utilization of ceria sol as a particle source, which was revealed by higher polarization resistance and greater low-frequency impedance modulus values for sol-derived composite coatings deposited under ultrasound.

20 December 2018 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
MBMihael Bucko
Mihael Bucko
SRS. Roy
S. Roy
Priscila Estefanía Valverde ArmasPriscila Estefanía Valverde Armas
Priscila Estefanía Valverde Armas
AOA. Onjia
A. Onjia
ABAlexandre Bastos
Alexandre Bastos
JBJelena Bajat
Jelena Bajat
This work investigates the electrochemical role of water in the research of deep eutectic solvent (DES) based on urea and choline chloride. The motivation comes from the growing use of this DES, and on reports where a characteristic voltammetric cathodic pre-wave is observed. However, there has been no direct study to verify if such interpretation of the pre-wave is appropriate. In this regard, cyclic voltammetry has been used in this paper to interrogate the reactions inducing the appearance of the pre-wave. These experiments have been carried out using reline (the eutectic mixture of urea and choline chloride) melts containing different amounts of water, compounds which can be incorporated as impurities from air, or as decomposition products of reline. The analyses showed that a pre-wave in voltammograms in reline originates from water electroreduction accompanied with a subsequent choline hydroxide formation. In this sense, reline behaves like a typical mixture of organic solvent + alkali cation salt + water. The voltammetric signal depends on water content in reline. Importantly, this offers a possibility for in-situ electrochemical determination of water content in reline, provided that a calibration curve is constructed.

1 January 2013 in Journal of the Serbian Chemical Society
Verified
Journal Article
Open access
PDF file
MBMihael Bucko
Mihael Bucko
ULUros Lacnjevac
Uros Lacnjevac
JBJelena Bajat
Jelena Bajat
Additives are necessary in the electrodeposition of Zn-Mn alloys at high current density, in order to reduce hydrogen evolution reaction and prevent dendrite formation. The influence of two aromatic aldehydes, 4-hydroxy-benzaldehyde and 3,4-dimethoxy-benzaldehyde, as the additives in Zn-Mn plating electrolyte, is examined in this work. The coatings characterization by scanning electron microscopy and X-ray energy dispersive spectroscopy, as well as the examination of additives effect by electrochemical methods, indicate a complex involvement of additive molecules in hydrogen evolution, as well as in Zn2+ and Mn2+ reduction. Consequently, the levelling action can be achieved and the chemical composition of the Zn-Mn alloy can be tailored, by adding the proper additive type and concentration in the plating electrolyte.

13 November 2021 in Journal of Electrochemical Science and Engineering
Verified
Journal Article
Open access
PDF file
MBMihael Bucko
Mihael Bucko
JBJelena Bajat
Jelena Bajat
Deep eutectic solvents (DESs) are a class of mixtures with melting points notably lower than those of their raw constituent components. These liquids have found a tremendously wide spectrum of applications in the last two decades of their research, so their contact and interaction with technical metals and alloys are inevitable. Therefore, the corrosivity of DESs towards metals is an extremely important topic. This review summarizes research efforts collected in the last two decades related to the corrosion rate of various metals in different DESs. Since the DESs are mainly composed of organic raw compounds, and by their physicochemical properties they may be regarded as a separate class of ionic liquids, the literature data about DESs corrosivity has been compared to the data related to the corrosivity of various organic solvents and ionic liquids as well. All the results gained until now show significantly low corrosivity of DESs. This observation is discussed in relation to the chemical composition of DESs. The absence of the oxidizing agents, the inhibitory action of organic ions and molecules, high viscosity and low electrical conductivity have been recognized as the main factors contributing to the low metal corrosion rate in DESs.

1 March 2017 in Archives of Environmental Protection
Verified
Journal Article
Open access
PDF file
MVMladen Vuruna
Mladen Vuruna
ZVZlate Sreten Veličković
Zlate Sreten Veličković
SPSreten Perić
Sreten Perić
JBJovica Bogdanov
Jovica Bogdanov
NINegovan Ivanković
Negovan Ivanković
MBMihael Bucko
Mihael Bucko
The most common chemical’s spills in typical transportation accidents are those with petroleum products such as diesel fuel, the consequence of which is an extensive pollution of the soil. In order to plan properly fuel recovery from the soil, it is important to gain information about the soil depth which may be affected by pollutant and to predict the pollutant concentration in different soil layers. This study deals with the impact of basic atmospheric conditions, i.e. air temperature and humidity on the diesel fuel migration through the soil. The diesel fuel was spilled into columns (L = 30 cm; D = 4.6 cm) filled with sandy and clay soil samples, and its concentrations at various depths were measured after 11 days under various air temperature (20 and 40°C) and relative humidity (30–100%) conditions. The effects observed were explained by understanding physical processes, such as fuel evaporation, diffusion and adsorption on soil grains. The increase in temperature results in higher fuel evaporation loss and its faster vertical migration. The relative humidity effect is less pronounced but more complex, and it depends much on the soil type.

1 January 2019 in Journal of the Serbian Chemical Society
Verified
Journal Article
Open access
PDF file
MBMihael Bucko
Mihael Bucko
MTMilorad V. Tomić
Milorad V. Tomić
MMMiodrag Maksimovic
Miodrag Maksimovic
JBJelena Bajat
Jelena Bajat
Cyclic voltammetry was used for the characterization of zinc electrodeposition on steel from ethaline deep eutectic solution (1:2 choline chloride: ethylene glycol). The influence of 4-hydroxy-benzaldehyde (HBA) as an additive was analyzed. It was shown that hydrogen evolution is inhibited in the presence of HBA and further significantly retarded upon addition of Zn2+ to the solution containing HBA. The cathodic peak for Zn2+ reduction in this type of ionic liquid (ethaline+HBA+Zn2+) resembles the zinc reduction in aqueous solution. The corrosion resistance of Zn coatings deposited at different current densities was evaluated by electrochemical methods, i.e., polarization measurements and electrochemical impedance spectroscopy in 3 % NaCl solution. The possibility of Zn?Mn alloy deposition from ethaline deep eutectic solvent was investigated for the first time. In addition, the corrosion stability of these alloy coatings was analyzed and compared to the stability of bare Zn coatings. It was shown that the optimum deposition current density for both Zn and Zn?Mn coatings with increased corrosion stability from ethaline + HBA electrolyte is 5 mA cm?2.