An analysis of the anodic reaction occurring at soluble copper anodes during the electrodeposition of copper from an ethaline-based deep eutectic solvent (DES) has been performed. It was shown by UV-Vis spectroscopy and electrochemical measurements that the dominant anodic species produced is the CuCl2− complex. In pure ethaline the current efficiency of the anodic process is 100% and the dissolution valency is one. However, in the presence of Cu(II) species the apparent dissolution valency measured gravimetrically was typically less than unity, corresponding to an observed mass loss greater than that expected from Faraday's law. Moreover, the apparent dissolution valency showed a marked dependence on the electrode rotation rate, Cu(II) concentration and the water content of the deep eutectic solvent. These observations were consistent with a corrosion reaction occurring in parallel with anodic dissolution. The most likely corrosion process is the comproportionation reaction: CuCl42− + Cu → 2CuCl2−. Voltammetric data indicate that the rate of this process is controlled by the mass transport of the CuCl42− complex to the surface and can readily explain the observed dissolution valency dependencies. Finally, it is noted that complex dissolution of Cu anodes in deep eutectic solvents makes their implementation as soluble anodes problematic.
Mining environmental liabilities (MEL) are of great concern because of potential risks to ecosystems and human health. In this research, the environmental risk (RI) related to MEL existing in three artisanal and small-scale gold-mining areas of Ecuador was evaluated. For this purpose, data of 167 MEL including landfills, mining galleries, tailing deposits, and mineral processing plants from Macuchi, Tenguel–Ponce Enriquez, and Puyango mining areas, were analyzed. The risk assessment related to the presence of waste deposits was carried out based on the methodology proposed by the Spanish Geological Survey. Moreover, the procedure outlined in the Environmental Risk Assessment Guide of the Ministry of Environment of Peru for nonwaste deposits was applied. The highest RI values were identified in Puyango and Tenguel–Ponce Enriquez. Thus, they were both categorized as priority control areas requiring intervention and rehabilitation plans. The MEL that require a high level of intervention include waste deposits and mine entrances associated with potentially toxic elements. Moreover, the point risk maps showed that rivers in the studied areas have a potential pollution risk. This study provides risk levels associated with MEL in mining areas from Ecuador. This information could be used for environmental management and pollution mitigation.
13 August 2023 in Case Studies in Chemical and Environmental Engineering
Groundwater is one of the main water sources for consumption, domestic use, agriculture, and tourism in coastal communities. However, high total dissolved solids (TDS) levels in the water (700–2000 mg L−1 TDS) and electrical conductivity (3000–5000 µS cm−1) threaten the health and economic growth opportunities for residents. This research aims to evaluate the performance of a laboratory-scale electrodialysis system as a technology for desalinating brackish water. For this purpose, water samples were collected from real groundwater sources. Batch experiments were conducted with varying operational parameters, such as voltage (2–10 V), feed volume (100–1600 mL), recovery rate (50–80%), and cros-flow velocity (1.3–5.1 cm s−1) to determine the electrodialysis system setup that meets the requirements for drinking water in terms of TDS and energy efficiency. A total specific energy consumption of 1.65 kWh m−3, including pumping energy, was achieved at a laboratory scale. The conditions were as follows: flow velocity of 5.14 cm s−1, applied voltage of 6 V, feed volume of 1.6 L, and a water recovery of 66%. Furthermore, increasing the flow velocity and the applied voltage enhanced the desalination kinetics and salt removal. Additionally, the system presented opportunities for scalability. This research aims to evaluate a sustainable membrane-based treatment technology for meeting the growing demand for water resources in coastal communities, particularly in developing countries in South America.