Commercially available multiwalled carbon nanotubes (MWCNT) were incorporated in coating masses based on PVC by means of three roll mill. The best results could be obtained using the 5 µm gap. Thin PVC sheets were formed via knife coating having an electrical conductivity up to 1,500 S/m that are applicable as electric heating elements. For the use in the antistatic range, CNT contents ≤0.5% are sufficient. Rheological measurements indicate the quality of particle processing. AFM investigations are suitable to investigate the alignment of the nanoparticles in the bulk polymer. Using this method, the decrease of agglomerates as well as the splitting of CNT bundles within further mass processing could be visualized.
In this work, silicone/carbon nanotube (CNT) composites were produced using a spread coating process, followed by morphological investigations and determination of their electrical properties and heating behaviour through the application of electric potential. Composites containing varying amounts of CNT (1–7%) were investigated for their thermal behaviour with the use of an IR camera. Subsequently, thermal behaviour and electrical properties were measured when the samples were stretched (up to 20%). With the 7% CNT composites, which had a conductivity of 106 S/m, it was possible to achieve a temperature of 155 °C at a relatively low voltage of 23 V. For high CNT contents, when the potential was controlled in such a way as to maintain the temperature well below 100 °C, the temperature remained almost constant at all levels of strain investigated. At higher potentials yielding temperatures around 100 °C and above, stretching had a drastic effect on temperature. These results are critical for designing composites for dynamic applications requiring a material whose properties remain stable under strain.
Superparamagnetic particles were widely used in medical applications as well as for magnetic sensors and actuators. Generally, the size of the particles is in the range of 10–20 nm. To use such particles in large-scale applications, a simple processing as well as the use of commercially available particles is required. Therefore superparamagnetic nanoparticles available on the market were incorporated in flexible polymer films and the magnetic properties of the films were investigated. At ambient temperature no significant hysteresis was observed, indicating the superparamagnetic properties. Films containing up to 25% nanoparticles were prepared. The films show a saturation magnetization of 13.8 Am2/kg and a coercivity of 7 Oe at ambient temperature.
The incorporation of MWCNTs in polymer systems up to the percolation range renders them electrically conductive. However, this conductivity is not high enough for heating applications in the low-voltage range (<24 V). The combination of nanoscaled MWCNTs with microscaled short SWCNT fibers that was investigated in this study causes an abrupt rise in the conductivity of the material by more than an order of magnitude. Silicone was used as a flexible and high-temperature-resistant matrix polymer. Conductive silicone coatings and films with SWCF contents of 1.5% to 5% and constant MWCNT contents of 3% and 5% were developed, and their electrical and thermal properties in the voltage range between 6 and 48 V were investigated. The electrical conductivity of 3% MWCNT composite materials rose with a 5% addition of SWCFs. Because of this spike in conductivity, output power of 1260 W/m2 was achieved, for example, for a 100 µm thick composite containing 3% MWCNT and 4% SWCF at 24 V with a line spacing of 20 cm. Thermal measurements show a temperature increase of 69 K under these conditions. These findings support the use of such conductive silicone composites for high-performance coatings and films for challenging and high-quality applications.