The presence of ten metals (Cd, Ni, Pb, Cr, Cu, Zn, Al, Fe, Mn, and Co) was investigated in the final discharge of six facilities, including four wastewater treatment plants, which were continuously discharging treated wastewater to the coastal environment in Gran Canaria Island. A four-day sampling campaign was carried out at each facility in July 2020, in which both the spot samplings technique and the diffusive gradient in thin-film technique (DGT) were carried out to measure total dissolved metals and the in situ labile metal fraction, respectively. After the necessary sample preparation steps, measurements were carried out by ICP-MS for both samplings. Raw data referred to the spot total dissolved and DGT-labile metal concentrations were reported. In general, the average metal concentrations were dispersed in a broad range. As expected, the highest metal contents were found in those facilities with larger industrial contributions. The values of annual average environmental quality standards (AA-EQS) were used to assess the total dissolved metal concentrations for every metal in every final discharge. In only one of the studied facilities, some metals (Ni and Zn) exceeded these EQS within the receiving waterbody, highlighting the need for more efficient treatment targeted towards a specific discharging-water quality. In addition, the total dissolved and labile metal daily fluxes of discharge were calculated to estimate the contribution of every effluent to the receiving water bodies.
Wastewater treatment plants (WWTPs) have been identified as significant point sources of microlitter particles (MPs) released into the environment. Simultaneously, they play a crucial role in effectively removing a substantial amount of MPs originated from domestic and industrial activities. This study evaluates the presence and chemical composition of MPs within the range of 5 mm to 25 µm in effluents from three WWTPs in the Canary Islands, each undergoing distinct treatment processes: pretreatment (PRET), activated sludge (AS), and membrane bioreactor (MBR) over an eight-month period. The concentrations of MPs exhibited substantial variations in the three effluent samples: 7461.50 ± 3843.87 MP/L in PRET, 32.71 ± 19.55 MP/L in AS, and 9.53 ± 5.21 MP/L in MBR. The predominant forms of MPs were fragments (58–66%) and fibers (27–33%), with the most prevalent size class being within the range of 150–25 µm. The mass concentrations of plastics, analyzed through pyrolysis gas chromatography–mass spectrometry (Pyr-GC/MS), were determined as 123.33 µg/L for PRET, 17 µg/L for AS, and 10 µg/L for MBR. This study revealed a diverse polymer profile, with polyvinyl chloride (PVC) and polyolefins (PE and PP) predominantly present. This work enhances our understanding of MP dynamics and provides a valuable reference for future assessments, aiding in the selection of effective removal technologies.
This good practice guide is focused on the DGT devices, which are the most widely used passive sampler for metals, covering the following aspects: ■ Principle ■ Handling passive sampling devices for metals ■ Estimation of appropriate field deployment time ■ A Good Practice Guide for the Use of DGTs ■ Passive sampling device preparation and assembly ■ Selection of sampling site and safety precautions ■ Passive sampling device deployment and retrieval ■ Extraction of analytes from passive sampling devices ■ Analysis ■ Calculations