This paper describes the high-rate (~1.5 μm/min) growth of Si films on Si supporting substrates with (100) crystallographic orientation at 600 °C, 800 °C, and 1000 °C in a vacuum environment of ~1 × 10⁻⁵ mbar using electron beam (e-beam) evaporation. The microstructure, crystallinity, and conductivity of such films were investigated. It was established that fully crystalline (Raman spectroscopy, EBSD) and stress-free epi-Si layers with a thickness of approximately 50 µm can be fabricated at 1000 °C, while at 600 °C and 800 °C, some poly-Si inclusions were observed using Raman spectroscopy. Hall effect measurements showed that epi-Si layers deposited at 1000 °C had resistivity, carrier concentration, and mobility comparable to those obtained for c-Si wafers fabricated through ingot growth and wafering using the same solar grade Si feedstock used for the e-beam depositions. The dislocation densities were determined to be ∼2 × 10⁷ cm⁻² and ∼5 × 10⁶ cm⁻² at 800 and 1000 °C, respectively, using Secco etch. The results highlight the potential of e-beam evaporation as a promising and cost-effective alternative to conventional CVD for the growth of epi-Si layers and, potentially, epi-Si wafers. Some of the remaining technical challenges of this deposition technology are briefly indicated and discussed.

Growing high-quality Si films at high rates with thicknesses ranging from the few nm- to µm-range while keeping the material consumption at a minimum is important for a wide range of Si-based technologies, spanning from batteries to sensors and solar cells. In this work, we elucidate the effects of electron beam deposition (e-beam) conditions on the growth of ~4 µm thick Si layers on bare and thermally oxidized (001)-oriented Si substrates. All depositions are performed from a stabilized and refillable melt of broken B-doped wafers and recollected using Si-shields during deposition for recycling. We find that increasing the deposition rate from 0.3 to 23 nm/s at a substrate temperature of 1000 °C reduces the roughness, void fraction, and residual stress of epitaxial Si-on-Si layers. For Si-on-$\mathrm{S}\mathrm{i}{\mathrm{O}}_2$, all films are polycrystalline under the same deposition conditions as for Si-on-Si, with a reduction in void fraction and increase in roughness at higher deposition rates. The residual stress for Si-on-$\mathrm{S}\mathrm{i}{\mathrm{O}}_2$ is comparable across all deposition rates >1 nm/s. Furthermore, we measure lower resistivities in the films than in the feedstock for Si-on-Si and higher than the feedstock for Si-on-$\mathrm{S}\mathrm{i}{\mathrm{O}}_2$. While the films become microstructurally denser and less defective at higher deposition rates, the resistivity increases for each next deposition step in the case of multi-step depositions from the same feedstock. Time-of-flight scanning secondary mass spectroscopy measurements show that the films have a significantly higher B-concentration than the feedstock, suggesting B-gettering to the melted region and transferring to the Si film upon the e-beam deposition process. This work demonstrates how electron beam evaporation can be used to recollect and recycle waste Si pieces, bringing important insights into how the deposition parameters influence the quality of the deposited polycrystalline as well as epitaxial thin-to-thick films.