When studying rockfall phenomena, a single value of the block volume is not sufficient to take into account the natural variability of the geometrical features (orientation, spacing, persistence) of the discontinuity sets. Different approaches for obtaining cumulative distributions of potentially detachable block volumes are compared. A highly fractured rock mass outcropping along the western Lake Garda (Italy), consisting of prevailing limestone and interbedded marls, is studied in detail from geological and geostructural points of view. Then, a representative rock face has been selected and analyzed with traditional and non-contact survey methods to identify the main discontinuity sets and to collect spacing samples. Based on these data, in situ block size distributions for different combinations of sets are built following statistically-based approaches, without the use of a Discrete Fracture Network (DFN) generator. The validation of the obtained distributions is attempted based on the detached block surveyed at the foot of the slope. However, in this particular case study, the detached blocks cover only a minimal volume range compared to both theoretical values and visible rockfall scars. The fallen rock blocks have a marginal role in design block determination, since their volume depends on geological discontinuities (bedding and fractures) and could be affected by other processes after the detachment (e.g., fragmentation). The procedure here described should be standard practice in the study of rockfall events, and it should be uniform in European standards such as Eurocodes. Future developments should involve the scientific community for setting the percentiles of the probability distribution to be considered for block design definition.

The main purpose of the present study is to develop a debris flow susceptibility map of a mountain area (Susa Valley, Western Italian Alps) by using an upgraded version of the Bonetto et al. (Journal of Mountain Science 18, 2021) approach based on the Rock Engineering System (RES) method. In particular, the area under investigation was discretized in a 5 × 5-m grid on which GIS-based analyses were performed. Starting from available databases, several geological, geo-structural, morphological and hydrographical predisposing parameters were identified and codified into two interaction matrices (one for outcropping lithologies and one for Quaternary deposits), to evaluate their mutual interactions and their weight in the susceptibility estimation. The result for each grid point is the debris flow propensity index (DfPI), an index that estimates the susceptibility of the cell to be a potential debris flow source. The debris flow susceptibility map obtained was compared with those obtained from two expedited and universally recognized susceptibility methods, i.e. the Regional Qualitative Heuristic Susceptibility Mapping (RQHSM) and the Likelihood Ratio (LR). Each map was validated by using the Prediction Rate Curve method. The limitations and strong points of the approaches analysed are discussed, with a focus on the innovativeness and uniqueness of the RES. In fact, in the study site, the RES method was the most efficient for the detection of potential source areas. These results prove its robustness, cost-effectiveness and speed of application in the identification and mapping of sectors capable of triggering debris flow.

In SW Piemonte the Western Alps arc ends off in a narrow, E-W trending zone, where some geological domains of the Alps converged. Based on a critical review of available data, integrated with new field data, it is concluded that the southern termination of Western Alps recorded the Oligocene-Miocene activity of a regional transfer zone (southwestern Alps Transfer, SWAT) already postulated in the literature, which should have allowed, since early Oligocene, the westward indentation of Adria, while the regional shortening of SW Alps and tectonic transport toward the SSW (Dauphinois foreland) was continuing. This transfer zone corresponds to a system of deformation units and km-scale shear zones (Gardetta-Viozene Zone, GVZ). The GVZ/SWAT developed externally to the Penninic Front (PF), here corresponding to the Internal Briançonnais Front (IBF), which separates the Internal Briançonnais domain, affected by major tectono-metamorphic transformations, from the External Briançonnais, subjected only to anchizonal metamorphic conditions. The postcollisional evolution of the SW Alps axial belt units was recorded by the Oligocene to Miocene inner syn-orogenic basin (Tertiary Piemonte Basin, TPB), which rests also on the Ligurian units stacked within the adjoining Apennines belt in southern Piemonte. The TPB successions were controlled by transpressive faults propagating (to E and NE) from the previously formed Alpine belt, as well as by the Apennine thrusts that were progressively stacking the Ligurian units, resting on the subducting Adriatic continental margin, with the TPB units themselves. This allows correlation between Alps and Apennines kinematics, in terms of age of the main geologic events, interference between the main structural systems and tectonic control exerted by both tectonic belts on the same syn-orogenic basin.

This research describes a quantitative, rapid, and low-cost methodology for debris flow susceptibility evaluation at the basin scale using open-access data and geodatabases. The proposed approach can aid decision makers in land management and territorial planning, by first screening for areas with a higher debris flow susceptibility. Five environmental predisposing factors, namely, bedrock lithology, fracture network, quaternary deposits, slope inclination, and hydrographic network, were selected as independent parameters and their mutual interactions were described and quantified using the Rock Engineering System (RES) methodology. For each parameter, specific indexes were proposed, aiming to provide a final synthetic and representative index of debris flow susceptibility at the basin scale. The methodology was tested in four basins located in the Upper Susa Valley (NW Italian Alps) where debris flow events are the predominant natural hazard. The proposed matrix can represent a useful standardized tool, universally applicable, since it is independent of type and characteristic of the basin.

In the frame of a regional study that is aimed at defining the landslide susceptibility in the upper Susa Valley (Western Italian Alps), this paper investigated the variation in the fracture network of rock masses in correspondence to faults zones. Fracture networks were characterized at sites located along transects that are oriented normally to fault traces and scattered in their adjacent sectors with the scope to be able to define and estimate the variation in fracture abundance in the bedrock. Fracture collection using a traditional geomechanical survey was combined with topological analysis to estimate the degree of fracturing of rock masses in terms of fracture intensity (P₂₁) and connectivity. Several sites were selected, and the variation in fracturing intensity values and degree of connectivity allowed for the defining of “high fracturing zones” (HFZ) near fault traces moving from the background values of adjacent rock masses. Considering the variation in fracture intensity, a range of 400 m to 150 m HFZ can be defined, with considerable differences between the areas analysed. The values recorded show a high irregular variability in fracture intensity in correspondence to the mapped faults due to the interference and overlay of structures related to the complexity setting of the fault damage zone.

Secondo Franchi (1859–1932) was one of the most important geologists of the Regio Ufficio Geologico of Italy. In collaboration with his colleagues of the Turin office, starting from 1888 Franchi surveyed in detail the Western Alps to contribute to the new Geological Map of Italy at the 1:100,000 scale. Franchi’s studies contributed to the definition of a still largely accepted chronostratigraphic framework for the Alpine successions, and to the recognition of previously overlooked folding and faulting phases in the Western Alps. Eleven of Franchi’s field notebooks are kept in the Library of Istituto Superiore per la Protezione e la Ricerca Ambientale in Rome. These notebooks are richly illustrated with geological sections and landscape sketches and represent an invaluable first- hand resource for the analysis of Franchi’s mapping methods and interpretive procedures. This paper analyses Franchi’s contribution to the geological knowledge of some specific localities of the Western Alps, integrating excerpts from his original field notebooks and published works.