The stabilisation of soft soils using the traditional binders cement and quicklime are known to emit large amounts of carbon dioxide. To reduce this carbon footprint, substitutes such as industrial by-products have been thoroughly tested as viable alternatives for soil stabilisation. However, recent research has also shown that biochar from biomass pyrolysis can in some instances have a positive stabilisation effect and even result in a carbon-negative footprint. This paper presents a laboratory study to investigate the stabilisation effect of five industrial by-products and four types of biochar on three natural Norwegian soils: two clays with low and high water contents and one peat with a very high water content. The soils and binders were characterised by their mineralogical and chemical compositions. The biochars had varying stabilisation effects on the clays when combined with cement, with some negative stabilisation effects, whilst the effect was very beneficial in the peat, with a strength increase of up to 80%. The industrial by-products showed opposite results, with beneficial effects in the clays and a strength increase of up to 150%, but negative stabilisation effects in the peat. Correlating the mineralogical and chemical compositions to stabilisation effects was found to be challenging.
The reclamation of acid-generating mine tailings typically involves building cover systems to limit interactions with water or oxygen. The choice of cover materials is critical to ensure long-term performance, and partly determines the environmental footprint of the reclamation strategy. The objective of this research was to evaluate if tailings pre-oxidized on-site could be used in cover systems. Column experiments were performed to assess the effectiveness of a cover with capillary barrier effects (CCBE), where the moisture retention layer (MRL) was made of pre-oxidized tailings with little to no remaining sulfides (LS tailings). The columns were submitted to regular wetting and drying cycles, and their hydrological and geochemical behaviour was monitored for 510 days. The LS tailings showed satisfying hydrological properties as an MRL and remained saturated throughout the test. The concentrations of Cu in the drainage decreased by more than two orders of magnitude compared to non-covered tailings. In addition, the pH increased by nearly one unit compared to the control column, and Fe and S concentrations decreased by around 50%. Despite these improvements, the leachate water remained acidic and contaminated, indicating that acid drainage continued to be generated despite a hydrologically efficient CCBE.
The Rosebank field, located in the Faroe-Shetland Basin, contains producible hydrocarbons in intra-basaltic siliciclastic reservoirs. The volcanic-reservoir interface is poorly studied and the geochemical system, as a function of distance from the basalt, is largely unknown. The current paper applies a geochemical model coupling mineral dissolution and precipitation with element diffusion to investigate the geochemical system in time and space from the basalt-sandstone interface. Earlier studies indicate few negative effects on reservoir properties despite the proximity to a reactive volcanic lithology. The causes of this minimal impact have not been studied. The numerical simulations in this study expand on the knowledge demonstrating that precipitation of authigenic phases at the basalt-sandstone interface buffer the formation water solution for key elements, which hamper the transport of solutes and subsequent precipitation of secondary minerals within the reservoir. Saturation index values over the simulated period indicate that precipitation of authigenic phases should not extend beyond the basalt-sandstone interface. This shows that diffusion alone is not enough to reduce the reservoir quality due to increased precipitation of secondary phases. The basalt dissolution rate varies according to the silica concentration. The combined effects on silica concentration by diffusional fluxes, mineral precipitation and dissolution, control the basalt dissolution rate, and there are no differences in the results between high and low basalt reactive surface area.