The stabilisation of soft soils using the traditional binders cement and quicklime are known to emit large amounts of carbon dioxide. To reduce this carbon footprint, substitutes such as industrial by-products have been thoroughly tested as viable alternatives for soil stabilisation. However, recent research has also shown that biochar from biomass pyrolysis can in some instances have a positive stabilisation effect and even result in a carbon-negative footprint. This paper presents a laboratory study to investigate the stabilisation effect of five industrial by-products and four types of biochar on three natural Norwegian soils: two clays with low and high water contents and one peat with a very high water content. The soils and binders were characterised by their mineralogical and chemical compositions. The biochars had varying stabilisation effects on the clays when combined with cement, with some negative stabilisation effects, whilst the effect was very beneficial in the peat, with a strength increase of up to 80%. The industrial by-products showed opposite results, with beneficial effects in the clays and a strength increase of up to 150%, but negative stabilisation effects in the peat. Correlating the mineralogical and chemical compositions to stabilisation effects was found to be challenging.
The dry deep mixing method using lime and cement-based binders is widely used in the Nordic countries to improve soft and sensitive clays. Increasing the usage of industrial by-products is needed to reduce climate impact, and this requires thorough knowledge on engineering properties using these binders. A lot of research has been done on this topic; however, tests are often performed on fabricated soils, and there is also a lack of studies on cement kiln dust in organic clays. This paper presents a large database of laboratory-improved soft inorganic and organic natural Swedish clays using quicklime, cement and cement kiln dust. It is shown that many properties and relationships between strength and stiffness, strength development over time and strain to failure are in practice similar for both quicklime and cement kiln dust when combined with cement, but that the strength depends both on the water-binder ratio and soil type. Further, it is shown that cement kiln dust performs well also in organic clay. The data also shows that the Youngs' modulus on average is around 100 times the unconfined compressive strength. For strength development over time, it is seen that the strength increases on average 60% from 7 days of curing to 28 days of curing. The correlations presented herein will serve as a useful guidance in engineering practice.
1 February 2025 in Journal of Geotechnical and Geoenvironmental Engineering
The dry deep mixing method is a widely used stabilization method in the Nordic countries to improve the strength and deformation properties of soft clays. In engineering practice, laboratory tests normally precede in situ stabilization; however, previous studies have shown considerable differences between field and laboratory stabilization. The type of laboratory molding technique will determine how representative the specimen is compared with field conditions. A key property is the amount of entrapped air in the stabilized clay, which is shown to be very low in field stabilization. This paper presents a study of two different Norwegian molding techniques, including different optimizations to reduce the amount of entrapped air. The specimens are tested for density and strength, and it is shown that the strength increases with increasing density of the stabilized clay. Consequently, there is an inverse relationship between the amount of entrapped air and the strength, showing the importance of reducing the amount of entrapped air in laboratory specimens as much as possible. It is also shown that the wet mixing method does not necessarily give the same strength development as dry deep mixing given the same water to binder ratio.