Currently, the production of one ton of ordinary Portland cement (OPC) releases considerable amounts of CO2 into the atmosphere. As the need and demand for this material grows exponentially, it has become a challenge to increase its production at a time when climate-related problems represent a major global concern. The two main CO2 contributors in this process are fossil fuel combustion to heat the rotary kiln and the chemical reaction associated with the calcination process, in the production of the clinker, the main component of OPC. The current paper presents a critical review of the existent alternative clinker technologies (ACTs) that are under an investigation trial phase or under restricted use for niche applications and that lead to reduced emissions of CO2. Also, the possibility of transition of clinker production from traditional rotary kilns based on fuel combustion processes to electrification is discussed, since this may lead to the partial or even complete elimination of the CO2 combustion-related emissions, arising from the heating of the clinker kiln.
In this work, the apparent activation energy (Ea) of a novel low-calcium binder was, for the first time, experimentally determined, using a calorimetric approach. Additionally, a correlation between the Ea, measured at the acceleration period with the C/S ratio of the hydration product is proposed. The Ea of the prepared pastes was determined through isothermal calorimetry tests by calculating the specific rate of reaction at different temperatures, using two different approaches. When comparing the Ea, at the acceleration period of this novel binder with the one published for alite and belite, we observed that its value is higher, which may be a result of a different hydration product formed with a distinct C/S ratio. Finally, to study the temperature effect on the compressive strength at early ages, a set of experiments with mortars was performed. The results showed that the longer the curing time at 35 °C, the higher the compressive strength after 2 days of hydration, which suggests a higher initial development of hydration products. This study also indicated that the novel binder has a higher sensitivity to temperature when compared with ordinary Portland cement (OPC).
Because of the severe environmental impact of the CO2 emissions associated with the production of ordinary Portland cement (OPC) and the increasing demand for this commodity material, the development of alternative products has become a global concern. One alternative to OPC, or alitic-based clinkers, are amorphous-wollastonitic low-calcium hydraulic binders (AWLCs). This new class of hydraulic binders, described in the literature for the first time in 2015, may significantly reduce the CO2 emissions associated with its production, resulting from its lower calcium content, but also from the fact that its production technology can be fully electrified. In this paper, a state-of-the-art review is presented, providing a comprehensive description of the latest research, summarizing both the physicochemical and mechanical characteristics of this type of hydraulic binder, as well as possible routes for its production at an industrial scale.
To ensure the acceptable mechanical strength of amorphous wollastonitic hydraulic binders (AWHs), activation with a sodium silicate solution is necessary. However, the use of this type of activator increases the final cost and the complexity of the product’s overall use. In this work, we focus on enhancing the manufacturing of the alkaline activator by producing three Na2SiO3 powders using cost-effective raw materials. The procedure consisted of heating a mixture of NaOH pebbles with either sand, glass, or diatomite to a temperature of 330 °C for 2 h. After synthesis, the powders were characterized by Fourier Transform Infrared Spectroscopy (FTIR) and X-ray Diffraction (XRD) techniques. Finally, mortars made with AWHs were activated using the synthesized powders that were added either as a solid or dissolved in an aqueous solution. The compressive strength results in these mortars show that the lab-made activators are competitive with the traditional sodium silicate activators. Furthermore, the synthetized activators can be added in either solid form or pre-dissolved in a solution. This innovative approach represents a more economical, sustainable and easy-to-use approach to enhancing the competitiveness of AWHs.