Nataša Samardžić

Dr. Nataša Samardžić

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 January 2012 in Sensors
Verified
Journal Article
Open access
PDF file
NJNikola Jerance
Nikola Jerance
DVDragana Vasiljevic
Dragana Vasiljevic
Nataša SamardžićNataša Samardžić
Nataša Samardžić
Goran M. StojanovicGoran M. Stojanovic
Goran M. Stojanovic
This paper describes the design, simulation and fabrication of an inductive angular position sensor on a flexible substrate. The sensor is composed of meandering silver coils printed on a flexible substrate (Kapton film) using inkjet technology. The flexibility enables that after printing in the plane, the coils could be rolled and put inside each other. By changing the angular position of the internal coil (rotor) related to the external one (stator), the mutual inductance is changed and consequently the impedance. It is possible to determine the angular position from the measured real and imaginary part of the impedance, in our case in the frequency range from 1 MHz to 10 MHz. Experimental results were compared with simulation results obtained by in-house developed software tool, and very good agreement has been achieved. Thanks to the simple design and fabrication, smaller package space requirements and weight, the presented sensor represents a cost-effective alternative to the other sensors currently used in series production applications.

13 March 2022 in Electronics
Verified
Journal Article
Open access
PDF file
Nataša SamardžićNataša Samardžić
Nataša Samardžić
JBJovan S. Bajić
Jovan S. Bajić
DSDalibor L. Sekulic
Dalibor L. Sekulic
Stanisa D DautovicStanisa D Dautovic
Stanisa D Dautovic
In this paper, circuit implementation of a leaky integrate-and-fire neuron model with a volatile memristor was proposed and simulated in the SPICE simulation environment. We demonstrate that simple leaky integrate-and-fire (LIF) neuron models composed of: volatile memristor, membrane capacitance and neuron resistance can mimic spatial and temporal integration, firing function and signal decay. The existing leaky term originates from the recovery of the initial resistive state in the memristor in the spontaneous reset cycle, which is essential for emulating the forgetting process in all-memristive neural networks (MNNs). Furthermore, a diffusive perovskite memristor was used to validate the model where intrinsic memristors’ capacitance acts as neuron membrane capacitance. Good agreement with experimental and simulation results was observed. Volatility, as an inherent property of specific memristors, eliminates the need for usage of an additional peripheral circuit which will reinitialize device state, thus allowing the development of energy-efficient, large scale complex memristive neural networks. The presented circuit level model of LIF neurons can facilitate the design of MNNs.

17 September 2021 in Electronics
Verified
Journal Article
Open access
PDF file
DSDalibor L. Sekulic
Dalibor L. Sekulic
Nataša SamardžićNataša Samardžić
Nataša Samardžić
ZMZivorad Mihajlovic
Zivorad Mihajlovic
MSMiljko V. Sataric
Miljko V. Sataric
In this paper, we performed analytical, numerical and experimental studies on the generation of soliton waves in discrete nonlinear transmission lines (NLTL) with varactors, as well as the analysis of the losses impact on the propagation of these waves. Using the reductive perturbation method, we derived a nonlinear Schrödinger (NLS) equation with a loss term and determined an analytical expression that completely describes the bright soliton profile. Our theoretical analysis predicts the carrier wave frequency threshold above which a formation of bright solitons can be observed. We also performed numerical simulations to confirm our analytical results and we analyzed the space–time evolution of the soliton waves. A good agreement between analytical and numerical findings was obtained. An experimental prototype of the lossy NLTL, built at the discrete level, was used to validate our proposed model. The experimental shape of the envelope solitons is well fitted by the theoretical waveforms, which take into account the amplitude damping due to the losses in commercially available varactors and inductors used in a prototype. Experimentally observed changes in soliton amplitude and half–maximum width during the propagation along lossy NLTL are in good accordance with the proposed model defined by NLS equation with loss term.

28 May 2022 in Ceramics International
Verified
Journal Article
Closed access
BBBranimir Bajac
Branimir Bajac
JVJelena Vukmirovic
Jelena Vukmirovic
Nataša SamardžićNataša Samardžić
Nataša Samardžić
JBJuras Banys
Juras Banys
GSGoran Stojanovic
Goran Stojanovic
VSVladimir V. Srdic
Vladimir V. Srdic

6 June 2017 in Journal of Electronic Materials
Verified
Journal Article
Closed access
PDF file
Nataša SamardžićNataša Samardžić
Nataša Samardžić
BBB. Bajac
B. Bajac
VSV. V. Srdic
V. V. Srdic
Goran M. StojanovicGoran M. Stojanovic
Goran M. Stojanovic

29 August 2019 in Electronics
Verified
Journal Article
Open access
PDF file
Goran M. StojanovicGoran M. Stojanovic
Goran M. Stojanovic
MPMilivoj Paroški
Milivoj Paroški
Nataša SamardžićNataša Samardžić
Nataša Samardžić
MRMilan Radovanovic
Milan Radovanovic
DKDejan Krstić
Dejan Krstić
The microfluidics domain has been progressing rapidly recently, particularly considering its useful applications in the field of biomedicine. This paper presents a novel, microfluidics-based design for four fundamental circuit elements in electronics, namely resistor, inductor, capacitor, and memristor. These widely used passive components were fabricated using a precise and cost-effective xurography technique, which enables the construction of multi-layered structures on foil, with gold used as a conductive material. To complete their assembly, an appropriate fluid was injected into the microfluidic channel of each component: the resistor, inductor, capacitor, and memristor were charged with transformer oil, ferrofluid, NaCl solution, and TiO2 solution, respectively. The electrical performance of these components was determined using an Impedance Analyzer and Keithley 2410 High-Voltage Source Meter instrument and the observed characteristics are promising for a wide range of applications in the field of microfluidic electronics.