This study focuses on the degradation behaviour of metallised film capacitors, which are the essential components for the stability of converter valves in flexible ultra‐high voltage direct current (HVDC) transmission systems. Through systematic experimentation, we investigated the failure mechanisms of MFCs under HVDC fields with superimposed harmonics, considering both equipment and material perspectives. The experiments subjected capacitors to 500 h of ageing under two conditions: a DC/AC‐superimposed field with a constant DC component of 290 kV/mm and an AC ripple rate varying from 12% to 28%, and a control group aged solely under a DC field. Our findings indicate that capacitors aged under the DC/AC‐superimposed field exhibited shorter lifespans and more significant capacitance loss than those aged under only the DC field. This difference in performance is primarily attributed to the distinct electrode loss behaviours observed under each ageing condition, which are key factors in the capacitors' capacitance decay. Moreover, the biaxially oriented polypropylene films in the DC‐aged samples showed more severe deterioration, characterised by more noticeable molecular chain scission and reduced breakdown strength, compared to those aged under the DC/AC superimposed field. This difference is partly due to the moderate temperature increase caused by harmonics, which benefits the aggregation structure, and partly to the reduced molecular structure damage from the AC field.
9 September 2024 in Journal of Materials Chemistry A
The enhancement of the energy storage property of capacitor films at elevated temperature has been considered a critical area of research owing to the essential requirements of capacitor applications. In the present study, a ternary composite system with an improved energy storage property is reported. The ternary composite was composed of PP-graft-AA chains (acrylic acid grafting) and a PP/nano-ZrO2 matrix and was biaxially oriented into a defect-free film with a thickness of 10 μm. The obtained film (BO(PP/AA/Zr)) exhibited an energy storage density of 7.9 J cm−3 at room temperature and maintained a considerably high value of 3.9 J cm−3 at 120 °C. The characterization of charge carrier transportation indicated that the effective biaxial orientation and the introduction of the polar grafted functional group and nanofillers increased the activation energy of molecular chain segment motion and deepened electron trap energy levels, which limited the transportation of charge carriers and significantly enhanced the breakdown strength and energy storage property. Moreover, the designed graft-modified chains (acrylic acid grafted) modified the compatibility between the polymer and inorganic nanofiller, thereby improving the processibility of the defect-free thin film. The results of dynamic mechanical analysis and 2D micro-infrared spectra indicated that the graft-modified chains offset the increased elastic rigidity caused by nanoparticles and facilitated the interaction between inorganic nano-ZrO2 and polymer chains. The study provides a potential solution to the challenge that nanocomposites face during the commercial production of defect-free biaxially oriented films.
Extensive research has focused on enhancing the energy storage density of polypropylene (PP) to meet the demands of high-power and compact electronic devices and electrical systems. However, there is a lack of studies addressing the delicate balance between energy storage density and dielectric loss. Dielectric loss can lead to excessive heat generation, posing a threat to the operation of energy storage capacitors. In this study, PP grafted with glycidyl methacrylate (GMA) was used as a compatibilizer and incorporated into a PP/nano ZrO2 blend to form a ternary system of PP/nano ZrO2/PP grafted GMA. A comparative study was conducted to analyze the effects of GMA grafting and individual doping of nano ZrO2 on the dielectric performance of PP. The results demonstrate that the ternary system not only ensures a high breakdown voltage (382.29 MV/m) but also possesses a high dielectric constant (2.67), thereby achieving an energy storage density of 1.7275 J/cm3 while maintaining low dielectric loss. Furthermore, grafting GMA introduces a significant number of deep traps, a phenomenon substantiated by the results of thermal stimulated depolarization current tests and molecular simulation calculations. However, the ternary system partially avoids the introduction of excessive deep traps associated with GMA grafting. This ternary system exhibits excellent energy storage performance, ease of fabrication, and stability, thereby enriching the research on polymer-based high-energy density dielectric materials.
Dielectric materials with enhanced energy storage performances are urgently demanded owing to the development of advanced capacitor equipment. However, low energy density and weak self-healing capabilities of current dielectric materials still limit the practical applications. Here, a biaxially oriented (polypropylene/2D Al2O3 nanosheets/grafted polypropylene) nanocomposite was proposed. The biaxial orientation enabled the directional arrangement of nanosheets in the polymer matrix. The oriented 2D nanosheets played a dominate role in the restriction of charge transportation and the tradeoff of energy consumption during breakdown and self-healing. Therefore, on one hand, the discharge energy density reached a considerable value of 9.64 J/cm3. On the other hand, the self-healing area of the metalized films was a 36% smaller than that of BOPP at the comparable self-healing energy, which was related to the long-term reliability of capacitor. The further experiments and simulations indicated that the oriented AONs arrangement suppressed electric field distortion and hindered the charge transportation, which greatly enhanced the breakdown strength and ultimately improved the energy storage performance. This strategy presented a potential solution for improving the energy storage performance of capacitor films, which is suitable for current industrial production.
Metallised film capacitors (MFC) can operate under much higher voltage compared to the foil capacitor due to their self‐healing (SH) properties, which caters to their application with high energy storage density requirement. Excellent results were achieved on the enhancement of the energy storage density of the dielectric material, whereas the SH properties of the modified material were less concerned. In the present study, the simultaneous improvement of the energy storage density and the SH properties were proposed, by constructing double‐layer metallised films of polypropylene (PP) and polymethyl methacrylate (PMMA). The breakdown strength of the PP/PMMA first increased and then decreased with the rising thickness of the PMMA layer. The dielectric constant was also raised because of the introduced ester groups. The highest energy storage density of 5.93 J/cm3 was obtained, which was 62.47% higher than the neat PP, whereas the dielectric loss was maintained around 0.01. The SH properties of PP/PMMA were systematically evaluated, that the SH energy decreased with the increasing PMMA ratio, and the equivalent conductivity at the SH point of the PP/PMMA decreased to only 1% of the neat PP, which largely benefit the stability of the MFC with reduced temperature rise.