Many attempts have been focused on the textile reinforced mortar structures. The advantages of textiles are mainly a very good load bearing capacity, excellent ductility, thin size and light weight of components, resistance to corrosion, and no magnetic disturbances. Such structures are expected to have wide application foregrounds. The transfer of forces from reinforcement to mortar is accomplished through a bond. Therefore, understanding and further improving bond properties of textiles in mortar are important. In the paper, bond characteristics of various textiles in mortar obtained from pull-out tests and numerical simulations are shown and compared. The textiles used include carbon, alkali resistant glass and aramid. They were plain and impregnated with epoxy resin. Prestressed and nonprestressed specimens were tested. The experimental results show that epoxy resin impregnating and prestressing can strongly enhance the bond strength. Numerical simulations show good agreement with the experimental res...
1 January 2003 in Journal of Advanced Concrete Technology
So far, the inspection of building structures and especially of bridges is mainly done visually. Therefore, the condition of the structure is examined from the surface and the interpretation and assessment is based on the experience of the expert. However, the main purpose of monitoring civil structures is not to substitute visual inspection. Continuous structural health monitoring should provide data from the inside of a structure to better understand its structural performance and to predict its durability and remaining life time. Monitoring should render objective data and observable alterations in the structure continuously, which cannot be done by visual inspection. More detailed information is needed with respect to different exposure due to dynamic and static loads and also temperature and moisture. Today mainly wired monitoring systems are used to monitor structures, which are relatively expensive and time consuming to install. In this paper the basic principle of a wireless monitoring system equipped with MEMS sensors is presented, which can be easily installed at different structures. Microelectromechanical systems (MEMS) are small integrated devices or systems that combine electrical and mechanical components. A wireless monitoring sensor network equipped with such MEMS could be produced with a very low budget and becomes very efficient. This permits a wide area of applications not only in civil engineering. With respect to different applications relevant properties of a wireless monitoring system are described. In detail network configuration, power consumption, data acquisition and data aggregation, signal analysis and data reduction as well as reliability and robustness are discussed.
In times of climate change, the reduction in embodied greenhouse gas emissions is a premise for sustainable concrete infrastructure. As Portland cement clinker is mainly responsible for the high CO2 emissions of concrete, its reduction is necessary. In order to be sustainable, the concrete must meet processing, mechanical and durability properties while taking cost aspects into account. The paper presents (i) the “micro-filler/eco-filler concept” for achieving a clinker reduced, optimised binder and (ii) a performance-based approach to put sustainable “Eco-concrete” into practice. Clinker is substituted by locally available inert fillers by at least two different particle size fractions and supplementary cementitious materials. The method is based on particle packing optimisation, reduction in water demand and optimisation of the mix ratio of the binder blend, which allows the performance requirements to be met. The new Eco-concretes deliver the desired performance in terms of processability, strength and durability (water penetration, frost, carbonation and chloride resistance) while lowering the environmental impact in comparison to standard concrete. One of the new mixes was used for a small animal passage tunnel. The direct comparison of the developed Eco-concrete and standard concrete showed a 24% reduction in CO2, while achieving satisfactory workability, stripping strength and durability performance.